Design of pliek-u dryer using Dafa-type solar energy
نویسندگان
چکیده
Abstract One of the food diversification strategies coconut commodity is to process it into Pliek U. U a typical Province Aceh, Indonesia, which in its processing stage requires drying process. So far, often conducted conventionally through direct (sun drying), so that produced susceptible dust and other dirt contamination. This research aimed design dryer using Dafa type solar energy. The energy used turbine ventilator with vertical axis wind equipped two collectors. had simple shape construction was arranged like letter S. While parts collector were collect from sun directly. In experiment, blank test carried out time range, namely 10.20 am 04.50 pm sunny weather, an interval 30 minutes for each temperature data recording. empty results showed average shelf 44.21 °C, 45.64 ambient 31.14 °C. initial revealed performance ability tool very effective maintaining during process, further tests materials may be out.
منابع مشابه
Design and optimization of solar-assisted conveyer-belt dryer for biomass
Biomass, as a renewable source of energy, can be used in many industries to reduce their dependence on fossil fuels. However, due to the significantly high and varied moisture content of biomass, its use has several drawbacks, such as low total efficiency and process instability. Drying biomass before combustion or gasification can eliminate these drawbacks. Besides these benefits, there ar...
متن کاملA review paper on Solar Dryer
The unpredictable rise and frequent scarcity of fossil fuel accelerated the continuous search for an alternative power source. Solar is one of the renewable and sustainable sources of power that attracted a large community of researchers from all over the world. This is largely due to its abundant in both direct and indirect form. As such the development of efficient and inexpensive equipment f...
متن کاملDeveloping off-design model of Yazd integrated solar combined cycle for analyzing environmental benefits of using solar energy instead of supplementary firing
An integrated solar combined cycle (ISCC) is analyzed at "off-design" operating conditions. Using the principles of thermodynamics heat and mass transfer a computer code is developed in FORTRAN programming language to simulate the system’s hourly performance under steady state conditions. Three scenarios are considered for the study. In the first one, only the combined cycle (CC) is studied. In...
متن کاملenergy and exergy analyses of thin layer drying of tomato in a forced solar dryer
in this paper the energy and exergy analyses in chamber drying process of thin layer drying of tomato in a forced solar drying was investigated. the experiments were carried out with two thicknesses of 5 and 7 and two airflows 0.5 m.s-1 and 1 m.s-1. during the experimental process, ambient temperature was between 22 and 36 , air relative humidity between was 14 and 50, and solar radiation range...
متن کاملModeling and Design of Solar Energy Systems including Solar Economics
1. F-Chart Method 1.1. Performance and Design of Liquid-Based Solar Heating Systems 1.1.1. Storage Capacity Correction 1.1.2. Collector Flow Rate Correction 1.1.3. Load Heat Exchanger Size Correction 1.2. Performance and Design of Air-Based Solar Heating Systems 1.2.1. Pebble Bed Storage Size Correction 1.2.2. Air Flow Rate Correction 1.3. Performance and Design of Solar Service Water Systems 1...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IOP conference series
سال: 2023
ISSN: ['1757-899X', '1757-8981']
DOI: https://doi.org/10.1088/1755-1315/1183/1/012047