Design of PI Controllers for Hydraulic Control Systems
نویسندگان
چکیده
منابع مشابه
Experimental Verification of Design Methods for Conventional PI/PID Controllers
The paper presents an experimental verification of conventional PI and PID controller design methods. Nine different synthesis techniques were used to control of airflow speed in laboratory model of hotair tunnel, most of them for both PI and PID version. In the first instance the controlled plant was identified in order to obtain a linear mathematical model and then the controllers were design...
متن کاملDesign of Robust PI Controllers for a Hydrogenerator Unit
In this paper, the sixteen plants theory (SPT) is applied to a hydrogenerator system model, which incorporates parametric uncertainty, in order to design a robustly stabilizing PI controller, which enhances the stability characteristics of the plant over a variety of ope-rating points. Key-Words: Power systems, parametric uncertainty, robust stabilization, Kharitonov theorem.
متن کاملDesign of Controllers PD, PI &PID for Speed Control of DC Motor Using IGBT Based Chopper
This paper presents a novel approach for determination of optimum values of Kp, Ki and Kd for design of controllers such as PD, PI & PID for enhancement of performance parameters of Permanent Magnet Direct Current (PMDC) Motor drives using IGBT based chopper in MATLAB/SIMULINK toolbox environments. The effectiveness of proposed novel approach has been presented so that the better performance pa...
متن کاملImproved relay auto tuning of P/PI controllers for unstable parallel cascade control systems
This paper focuses on simultaneous relay auto tuning of open loop unstable parallel cascade systems. For stable parallel cascade systems,Vivek and Chidambaram[1] had discussed effect of higher order harmonics of symmetrical relay output, which accounts for error in ultimate controller gain estimation. In the present work, this method is extended to parallel cascade controllers for open loop uns...
متن کاملOn Tuning PI Controllers for Integrating Plus Time Delay Systems
Some analytical results concerning PI controller tuning based on integrator plus time delay models are worked out and presented. A method for obtaining PI controller parameters, Kp = α kτ , and, Ti = βτ , which ensures a given prescribed maximum time delay error, dτmax, to time delay, τ , ratio parameter δ = dτmax τ , is presented. The corner stone in this method, is a method product parameter,...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Mathematical Problems in Engineering
سال: 2013
ISSN: 1024-123X,1563-5147
DOI: 10.1155/2013/451312