Design of LTBC Controller for Tension Control in Down Coiler Process of Hot Strip Mills

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Coiler Control in Endless Hot Strip Rolling

JFE Steel Corporation’s East Japan Works (Chiba District) started operation of No.3 Hot Strip Mill in 1995. This line was the first in the world to achieve “endless hot strip rolling.” A new Coiler Control technology was developed. Copyright 2005 IFAC

متن کامل

Tension Control with ARHC Scheme for Hot Strip Finishing Mills

This paper presents a design procedure of the ARHC(Adaptive Receding Horizon Control) of the looper-tension controller in hot strip finishing mill. The controller is applied to satisfy the constraints of the control input and attenuate the disturbance of the actuator. The system matrices of the looper model are periodically updated during online simulation. Moreover the closed loop stability of...

متن کامل

Microstructure prediction and control in hot strip mills *Dr

A key determinant of the quality of hot-rolled strip is mechanical properties lying within the tolerance range. Traditionally, this is done by testing samples which is costly, time-consuming and ties up stock awaiting test results. An alternative is given by MicroStructureMonitor, a computer model-based system which calculates the required quality parameters rather than measuring them and addit...

متن کامل

design of an analog fuzzy logic controller chip

fuzzy logic has been developed over the past three decades into a widely applied techinque in classification and control engineering. today fuzzy logic control is one of the most important applications of fuzzy set theory and specially fuzzy logic. there are two general approachs for using of fuzzy control, software and hardware. integrated circuits as a solution for hardware realization are us...

15 صفحه اول

Looper-Tension Control for Hot Strip Finishing Mills Based On the Combination of H∞ and ISMC Approaches

The development of an innovative controller for looper and tension control in hot strip finishing mills is traced based on the combination of H∞ and ISMC (integral sliding mode control) approaches. First, an H∞ controller is designed to robustly attenuate the unmatched disturbances in the angle and tension loops. Then, ISMC is used to overcome the matched disturbances in the actuators which gua...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Journal of Institute of Control, Robotics and Systems

سال: 2015

ISSN: 1976-5622

DOI: 10.5302/j.icros.2015.14.8037