Design of Low Power Low Noise Amplifier using Gm-boosted Technique
نویسندگان
چکیده
منابع مشابه
Design of Low Power Low Noise Amplifier using Gm-boosted Technique
Received Sep 19, 2017 Revised Dec 30, 2017 Accepted Jan 17, 2018 This paper presents the development of low noise amplifier integrated circuit using 130nm RFCMOS technology. The low noise amplifier function is to amplify extremely low noise amplifier without adding noise and preserving required signal to a noise ratio. A detailed methodology and analysis that leads to a low power LNA are being ...
متن کاملA W-band Simultaneously Matched Power and Noise Low Noise Amplifier Using CMOS 0.13µm
A complete procedure for the design of W-band low noise amplifier in MMIC technology is presented. The design is based on a simultaneously power and noise matched technique. For implementing the method, scalable bilateral transistor model parameters should be first extracted. The model is also used for transmission line utilized in the amplifier circuit. In the presented method, input/output ma...
متن کاملGm-boosted Flat Gain UWB Low Noise Amplifier with Noise Cancellation
This paper presents a high power gain (S21) and low Noise Figure (NF) 3.1-10.6 GHz common gate (CG) CMOS ultra wideband (UWB) low noise amplifier (LNA) using active gm-boosted technology, T-match input network, self-body-bias, current reused and noise cancelling technique. Wideband input impedance matching was achieved by using the proposed T-match input network to improve the input matching at...
متن کاملLow-power Adaptive Bipolar Low Noise Amplifier
In this paper, a low-power adaptive low noise amplifier (LNA) is presented. The LNA is based on a bipolar cascode topology, uses inductive source degeneration and emitter area scaling to achieve noise and input-impedance matching simultaneously. The input impedance and the noise factor were simulated as function of the bias collector current and the results show that both are approximately cons...
متن کاملLow Power Low Noise CMOS Chopper Amplifier
AbstractChopping is a proficient way to reduce the low frequency offset and 1/f noise in amplifiers. In this paper, a low power low noise CMOS chopper amplifier is presented. It is composed of a two stage amplifier. The first stage’s high output impedance and the equivalent Miller capacitance of the second stage constitute together a low pass filter, which reduces the power consumption. The cir...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Indonesian Journal of Electrical Engineering and Computer Science
سال: 2018
ISSN: 2502-4760,2502-4752
DOI: 10.11591/ijeecs.v9.i3.pp685-689