Design of LED Driver Power Based on LNK417EG
نویسندگان
چکیده
منابع مشابه
application of upfc based on svpwm for power quality improvement
در سالهای اخیر،اختلالات کیفیت توان مهمترین موضوع می باشد که محققان زیادی را برای پیدا کردن راه حلی برای حل آن علاقه مند ساخته است.امروزه کیفیت توان در سیستم قدرت برای مراکز صنعتی،تجاری وکاربردهای بیمارستانی مسئله مهمی می باشد.مشکل ولتاژمثل شرایط افت ولتاژواضافه جریان ناشی از اتصال کوتاه مدار یا وقوع خطا در سیستم بیشتر مورد توجه می باشد. برای مطالعه افت ولتاژ واضافه جریان،محققان زیادی کار کرده ...
15 صفحه اولAn Isolated Off-Line High Power Factor Electrolytic Capacitor-Less LED Driver with Pulsating Output Current
One of the most efficient lighting technology is based on light-emitting diodes (LEDs). Common LED drivers with AC-input (50-60Hz) usually require a bulk electrolytic capacitor to decrease low-frequency ripple in the output. However, the critical element that limits the lifespan of the LED driver is the electrolytic capacitor. An isolated off-line LED driver is proposed in this paper, in which ...
متن کاملAnalysis and Design of the Integrated Double Buck-Boost Converter as a High-Power-Factor Driver for Power-LED Lamps
The IDBB converter features just one controlled switch and two inductors and is able to supply a solid-state lamp from the mains providing high power factor and good efficiency. And with a careful design of the converter the filter capacitances can be made small enough so that film capacitors may be used. Thus the converter mean time between failures can be made as high as that of the solid-sta...
متن کاملDesign for Low Power HB-LED Lighting
This paper presents an improved power quality converter (IPQC) based power supply design for high brightness Light Emitting Diode (HB-LED) low power lighting. The IPQC circuit uses a Cuk buck-boost converter to operate it in discontinuous conduction mode (DCM) using voltage follower technique for the mitigation of harmonic contents present in the AC mains current. Subsequently reduction in harm...
متن کاملDesign Guideline on 150W Power Supply for LED
This application note describes a 150W rating design guideline for LED street lighting. The application design consists of CRM PFC and LLC SRC with high power factor and high power conversion efficiency using FL7930B and FAN7621S. To verify the validity of the application board and scheme, a demonstration board 150W (103V/1.46A) AC-DC converter was implemented and its results are presented in t...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IOSR Journal of Electrical and Electronics Engineering
سال: 2017
ISSN: 2320-3331,2320-3331
DOI: 10.9790/1676-1201041622