Design of DubaiSAT-1 S-band Receiver RF block
نویسندگان
چکیده
منابع مشابه
Typical Ka band Satellite Beacon Receiver Design for Propagation Experimentation
This paper presents the design and simulation of a typical Ka band satellite beacon receiver for propagation experimentation. Using satellite beacon signal as a reference signal in satellite wave propagation study, is one of the most important methods. Satellite beacons are frequently available for pointing large antennas, but such signals can be used for measuring the effect of natural phenome...
متن کاملSystem Level Design of Multi-standard Receiver Using Reconfigurable RF Block
In this paper, we review the four receiver architectures and four methods for multi-standard receiver design. Propose reconfigurable RF block can be used for both low-IF and direct conversion architecture. Also, using reconfigurable mixer method, it can be operated at 2~6 GHz range for multistandard receiver. It consists of wideband mixer, filter, and automatic gain control amplifier and to get...
متن کاملNon Contiguous Tri-band Receiver for Carrier Aggregation RF System
The carrier aggregation technique will allow an increase of capacity of the 4 Generation mobile communication networks (LTE-A: Long Term Evolution Advanced). The probability to find carriers that occupy a continuous spectrum in frequency is very low. The challenge is to demodulate an RF signal where the information is distributed on non-contiguous frequency bands. The technique presented in thi...
متن کاملDesign of an S-band Ultra-low-noise Amplifier with Frequency Band Switching Capability
In this paper, an ultra-low-noise amplifier with frequency band switching capability is designed, simulated and fabricated. The two frequency ranges of this amplifier consist of the 2.4 to 2.5 GHz and 3.1 GHz to 3.15 GHz frequency bands. The designed amplifier has a noise figure of less than 1dB, a minimum gain of 23 dB and a VSWR of less than 2 in the whole frequency band. The design process s...
متن کاملtypical ka band satellite beacon receiver design for propagation experimentation
this paper presents the design and simulation of a typical ka band satellite beacon receiver for propagation experimentation. using satellite beacon signal as a reference signal in satellite wave propagation study, is one of the most important methods. satellite beacons are frequently available for pointing large antennas, but such signals can be used for measuring the effect of natural phenome...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Korean Society for Aeronautical & Space Sciences
سال: 2011
ISSN: 1225-1348
DOI: 10.5139/jksas.2010.39.2.178