Design of an Advanced Bearing System for Total Knee Arthroplasty

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Advantages of Mobile-bearing Total Knee Arthroplasty

Early historical failure of total knee arthroplasty (TKA) was frequently secondary to aseptic loosening, often associated with malalignment, instability, or use of excessively constrained prosthetic components. With the addition of better surgical instrumentation and operative techniques (ligamentous balancing, improved alignment, etc.) and the use of lowerconformity prosthetic devices, looseni...

متن کامل

Fixed or mobile-bearing total knee arthroplasty

Fixed and mobile-bearing in total knee arthroplasty are still discussed controversially. In this article, biomechanical and clinical aspects in both fixed and mobile-bearing designs were reviewed. In biomechanical aspect, the mobile-bearing design has proved to provide less tibiofemoral contact stresses under tibiofemoral malalignment conditions. It also provides less wear rate in in-vitro simu...

متن کامل

Modular, mobile-bearing hinge total knee arthroplasty.

Early reports of hinge total knee arthroplasty showed high rates of complications and implant failure. Third-generation modular, mobile-bearing, hinge knee arthroplasty systems have evolved to decrease the deleterious stresses that contributed to the failures of earlier designs. The combined series of Barrack et al and Jones et al documents midterm results using the S-ROM Hinge Knee System for ...

متن کامل

DIFFERENT REFERENCES FOR VALGUS CUT ANGLE IN TOTAL KNEE ARTHROPLASTY

This was Presented in 5th International congress of Iranian Iranian Society of Knee Surgery, Arthroscopy, and Sports Traumatology (ISKAST), 14-17 Feb 2018- Kish, Iran

متن کامل

Early outcomes of twin-peg mobile-bearing unicompartmental knee arthroplasty compared with primary total knee arthroplasty

AIMS Since redesign of the Oxford phase III mobile-bearing unicompartmental knee arthroplasty (UKA) femoral component to a twin-peg design, there has not been a direct comparison to total knee arthroplasty (TKA). Thus, we explored differences between the two cohorts. PATIENTS AND METHODS A total of 168 patients (201 knees) underwent medial UKA with the Oxford Partial Knee Twin-Peg. These pati...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Lubricants

سال: 2015

ISSN: 2075-4442

DOI: 10.3390/lubricants3020475