Design of an 87% Fractional Bandwidth Doherty Power Amplifier Supported by a Simplified Bandwidth Estimation Method
نویسندگان
چکیده
منابع مشابه
Designing an Octave-bandwidth Doherty Am- Plifier Using a Novel Power Combination Method
In this paper, an octave bandwidth Doherty power amplifier (DPA) using a novel combiner is presented. The fundamental bandwidth limitation of the load modulation concept of a conventional Doherty structure is solved based on the proposed combination method. For verification, an octave bandwidth asymmetric Doherty architecture is implemented by using gallium-nitride (GaN) HEMT Cree CGH40010 and ...
متن کاملHigh bandwidth low power operational amplifier design and compensation techniques
The need for high bandwidth operational amplifiers (op amp) exists for numerous applications. This need requires research in the area of op amp bandwidth extension. The exploited method in this thesis uses a class of compensation called Indirect Feedback Frequency Compensation in which the compensation current is fed back indirectly from the output to an internal high impedance node, to extend ...
متن کاملFeedback for High-Bandwidth Power Amplifier Linearization
Current RF power amplifier (PA) linearization techniques are presently being investigated to improve PA linearity and power efficiency. One such linearization technique, Cartesian feedback (CFB), makes use of analog feedback to linearize a nonlinear plant (Figure 1). The commanded baseband symbol, I and Q, are compared to the symbol being transmitted by the PA, the baseband symbol is predistort...
متن کاملDesign of a High-Bandwidth Y-Shaped Photonic Crystal Power Splitter for TE Modes
In this paper, a Y-shaped power splitter based on a two dimensional photonic crystal (PhC) for TE modes is designed and optimized. A triangular lattice of air holes is used for Y-shaped power divider. For analyzing these structures, plane wave expansion (PWE) and finite difference time domain (FDTD) methods are used. The simulation results show that more than 98% of the input power is transmitt...
متن کاملDesign of a Three-Stage High-Bandwidth CMOS Transimpedance Amplifier
This report describes the development of a transimpedance amplifier that takes current as input and gives voltage as output. The amplifier consists of three CMOS amplifier stages in a fed-back configuration, achieving a transimpedance gain over 3 kΩ and a 3-dB bandwidth greater than 2.8 GHz. The amplifier operates with a 1.5 V supply voltage and a power budget of 30 mW.
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IEEE Transactions on Microwave Theory and Techniques
سال: 2018
ISSN: 0018-9480,1557-9670
DOI: 10.1109/tmtt.2017.2767586