Design of a 1~10 GHz High Gain Current Reused Low Noise Amplifier in 0.18 ㎛ CMOS Technology
نویسندگان
چکیده
منابع مشابه
Analysis and design of a CMOS current reused cascaded distributed amplifier with optimum noise performance
In this paper, analysis, simulation and design of a distributed amplifier (DA) with 0.13µm CMOS technology in the frequency range of 3-40 GHz is presented. Gain cell is a current reused circuit which is optimum in gain, noise figure, bandwidth and also power dissipation. To improve the noise performance in the frequency range of interest, a T-matching low pass filter LC network which is utilize...
متن کاملA 60-GHz Low Noise Amplifier in 0.13-μm CMOS
The low noise amplifier (LNA) serves as the first component of the radio frequency receiver system. The performance of LNA determines the sensitivity and selectivity of the receiver. In order to maximize performance the gain, noise figure and input matching of LNA needs to be optmized. This paper presents a 60GHz low noise amplifier on 0.13-μm standard CMOS technology designed using classical n...
متن کاملA 0.18um CMOS Current Reused Low-Noise Amplifier with Gain Compensated for Ultra-Wideband Wireless Receiver
A current reused low-noise amplifier (LNA) with gain compensated to extend the bandwidth and is designed for ultra-wideband (UWB) wireless receiver. The design consists of two cascode common-source amplifier and an output buffer which is implemented in 0.18um RF CMOS process. The LNA gives 13.1dB gain; 9.1GHz 3dB bandwidth (3.1-12.2GHz) while consuming 13.9mW through a 1.8V supply. Over the 3.1...
متن کاملDesign and Implementation of a 1-5 GHz UWB Low Noise Amplifier in 0.18 μm CMOS
This paper presents a compact two-stage ultrawideband low-noise amplifier (LNA). A common-gate topology is adopted for the input stage to achieve wideband input matching, while a cascode stage is used as the second stage to provide power gain at high frequencies. A low power consumption and a small chip area are obtained by optimizing the performance of the LNA with tight constraint on biasing ...
متن کاملA 1.8 GHz CMOS Low-Noise Amplifier
A 1.8 GHz low-noise amplifier has been designed and fabricated in a standard 0.35 pm CMOS process. Measurement results indicate that the amplifier has a forward gain (S21) of 10.5 dB and a noise figure of 3.94 dB, while consuming 40 mW from a 2.5 V supply.
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of electromagnetic engineering and science
سال: 2011
ISSN: 2234-8409
DOI: 10.5515/jkiees.2011.11.1.027