Design of 12T SRAM cell for low power dissipation
نویسندگان
چکیده
منابع مشابه
Design of Ultra Low Power SRAM Cell
In order to achieve a longer battery life suppression of energy consumption is vital. A demand for design methods for less energy consumption is increasing. The subthreshold scaling can reduce energy per cycle significantly by the scaling of supply voltage (VDD) below threshold voltage (Vth). Threshold voltage of CMOS technology represents the value of the gate-source voltage when the current i...
متن کاملDesign of Low Power Sram Memory Using 8t Sram Cell
Low power design has become the major challenge of present chip designs as leakage power has been rising with scaling of technologies. As modern technology is spreading fast, it is very important to design low power, high performance, and fast responding SRAM (Static Random Access Memory) since they are critical component in high performance processors. The Conventional 6T SRAM cell is very muc...
متن کاملDesign of High Speed and Low Power 4t Sram Cell
Portable devices demand for low power dissipation. To reduce power dissipation, the subsystem in a device needs to be designed to operate at low power and also consume low power. Significant progress has been made in low power design of dynamic RAM’s. Static RAM’s are also critical in most VLSI based system on chip applications. Basic SRAM bit cell consists of 6T. Few designs using 4T are also ...
متن کاملDesign of a Low Power 10T SRAM Cell
SRAM is a semiconductor memory cell. In this paper, a 10T SRAM cell is designed by using cadence virtuoso tool in 180nm CMOS technology. Its performance characteristics such as power, delay, and power delay product are analysed. 10T SRAM cell is basically 6T SRAM cell with 4 extra transistors. In this 10T SRAM cell, additional read circuitry is attached to avoid flipping of cell. The power diss...
متن کاملLow Power 10T SRAM Design for Dynamic Power Reduction
The aim of paper is to get over the problem of 6T SRAM cell where it loses its reliability at low supplies due to degraded noise margins. These is done by using a 10T SRAM where the cell uses a charge sharing technique between the transistors so that SRAM could be made more rigid against the noises that can cause damage to the cell at low power supplies and along with that charge sharing betwee...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IOP Conference Series: Materials Science and Engineering
سال: 2020
ISSN: 1757-899X
DOI: 10.1088/1757-899x/994/1/012045