Design and Simulation of Cascaded Class-A Microwave Power Amplifier
نویسندگان
چکیده
منابع مشابه
Design of a Class F Power Amplifier
A Class F power amplifier (PA) at 2.5GHz has been designed and fabricated. Test results show 15.7 dB gain with 75.75% power added efficiency (PAE ), at an input level of 25 dBm. The design procedure is presented, with various issues illustrated and addressed. A new method is proposed to obtain the optimum load and source impedances without iterations, which would usually be necessary.
متن کاملDesign, Analysis and Simulation of a Linear Phase Distributed Amplifier
In this paper a new method for the design of a linear phase distributed amplifier in 180nm CMOS technology is presented. The method is based on analogy between transversal filters and distributed amplifiers topologies. In the proposed method the linearity of the phase at frequency range of 0-50 GHz is obtained by using proper weighting factors for each gain stage in cascaded amplifier topology....
متن کاملAnalysis and design of a CMOS current reused cascaded distributed amplifier with optimum noise performance
In this paper, analysis, simulation and design of a distributed amplifier (DA) with 0.13µm CMOS technology in the frequency range of 3-40 GHz is presented. Gain cell is a current reused circuit which is optimum in gain, noise figure, bandwidth and also power dissipation. To improve the noise performance in the frequency range of interest, a T-matching low pass filter LC network which is utilize...
متن کاملAnalysis and Simulation of Memory Effects on Microwave Power Amplifier
Analysis and simulation the existence of electrical memory effects and thermal memory effects in different spacing two-tone input signal and modulated signal source through advanced design system (ADS) software simulation, respectively. Built thermal memory effects compensation circuit in the ADS environment to confirm the compensation circuit has a good compensation to the thermal memory effec...
متن کاملNon-linear modeling, analysis, design and simulation of a solid state power amplifier based on GaN technology for Ku band microwave application
A new non-linear method for design and analysis of solid state power amplifiers is presented and applied to an aluminum gallium nitride, gallium nitride (AlGaN-GaN) high electron-mobility transistor (HEMTs) on silicon-carbide (SiC) substrate for Ku band (12.4 13.6 GHz) applications. With combining output power of 8 transistors, maximum output power of 46.3 dBm (42.6 W), PAE of 43% and linear ga...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Electrical and Computer Engineering (IJECE)
سال: 2013
ISSN: 2088-8708
DOI: 10.11591/ijece.v3i5.3644