Design and Optimization of Special-Purpose Tower Crane for Large Tower of Transmission Line
نویسندگان
چکیده
منابع مشابه
Automatic Design Algorithm for the Tower Crane Foundations
Foundation of tower crane serves to ensure stability against vertical and horizontal forces. If foundation stress is not sufficient, tower crane may be subject to overturning, shearing or foundation settlement. Therefore, engineering review of stable support is a highly critical part of foundation design. However, there are not many professionals who can conduct engineering review of tower cran...
متن کاملAnalysis of a Tower Crane Accident
Today, steel tower cranes are widely used in the construction sites. In this study, the accident occurred in Turkey in 2006 with the overturning of a tower crane in a construction site and the damage occurred on the nearby buildings due to this accident were taken into consideration. At first, the technical characteristics of the EC-H type tower crane used in that construction and then the reas...
متن کاملExperimental Investigation of Impulse Characteristics of Transmission Line Tower Footings
Understanding the impulse response of tower grounding systems is a key factor in the determination of the lightning performance of transmission lines and the safety voltages near high voltage towers. This paper reports the results of an experimental study on the impulse characteristics of full-scale transmission line tower footings. The ground potential distribution both at the ground surface a...
متن کاملLimit State Evaluation for Transmission Tower-Line System
The physical infrastructure of the power systems, including the high-voltage transmission towers and lines as well as the poles and wires for power distribution at a lower voltage level, is critical for the resilience of the community to avoid power outages under the extreme weather related loads. In the current engineering practices, single circuit lattice steel towers linked by transmission l...
متن کامل3D Tower Crane as a mechatronic tool for education
The paper presents a laboratory model of the 3D tower crane. The arm of the crane is approx 1.2m long and the model is approx. 1.5m heigh. The crane is equipped with three DC motors that control: the rotary movement of the tower, the movement of the trolley and up and down movement of the load. The model is equipped with an unique unit for measuring an angle position of the load. The paper cont...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Mechanical Engineering and Technology
سال: 2015
ISSN: 2167-6631,2167-6623
DOI: 10.12677/met.2015.42009