Design and Optimization of PMSM for Injection Molding Machine

Finite Element Analysis and Design Optimization of Platen for Injection Molding Machine

Plastics are certainly most versatile of all known materials today and have therefore, established themselves in enviable position from where are not even possible to replaced. Injection molding machine is one of the most widely used method of conversion of plastic into various end products application to wide range of plastic materials from plastic commodity to specialty engineering plastic. I...

Multidisciplinary optimization of injection molding systems

The design of injection molding systems for plastic parts relies heavily on experience and intuition. Recently, mold makers have been compelled to shorten lead times, reduce costs and improve process performance due to global competition. This paper presents a framework, based on a Multidisciplinary Design Optimization (MDO) methodology, which tackles the design of an injection mold by integrat...

Development of an Intelligent Cavity Layout Design System for Injection Molding Dies (RESEARCH NOTE)

This paper presents the development of an Intelligent Cavity Layout Design System (ICLDS) for multiple cavity injection moulds. The system is intended to assist mould designers in cavity layout design at concept design stage. The complexities and principles of cavity layout design as well as various dependencies in injection mould design are introduced. The knowledge in cavity layout design is ...

Optimization of the injection molding process of Derlin 500 composite using ANOVA and grey relational analysis

Warpage and shrinkage control are important factors in proving the quality of thin-wall parts in injection modeling process. In the present paper, grey relational analysis was used in order to optimize these two parameters in manufacturing plastic bush of articulated garden tractor. The material used in the plastic bush is Derlin 500. The input parameters in the process were selected according ...

Effective Run-In and Optimization of an Injection Molding Process