Design and Operation of a Portable, Digital Impulse Radar
نویسندگان
چکیده
منابع مشابه
Design and Implementation of Digital Demodulator for Frequency Modulated CW Radar (RESEARCH NOTE)
Radar Signal Processing has been an interesting area of research for realization of programmable digital signal processor using VLSI design techniques. Digital Signal Processing (DSP) algorithms have been an integral design methodology for implementation of high speed application specific real-time systems especially for high resolution radar. CORDIC algorithm, in recent times, is turned out to...
متن کاملa study on the design of bio-ethanol process from date wastes of sistan and baluchistan province
اتانول کاربردهای متنوعی در صنایع لاستیک سازی، رنگسازی، حلالها ومکمل سوخت خودرو دارد. اتانول برخلاف نفت از جمله مواد تجدیدپذیر محسوب می شود که مشکلات زیست محیطی و آلودگی نیز ایجاد نمی کند. استفاده از اتانول به عنوان مکمل سوختخودروها از جمله مهمترین مصارف صنعتی این ماده بشمار می رود. با توجه به این موضوع تحقیق و توسعه در زمینه تولید اتانول با درجه خلوص بالا در سطح جهان، و نه تنها در کشور های پیشر...
Design, Performance and Optimization for Multimodal Radar Operation
This paper describes the underlying methodology behind an adaptive multimodal radar sensor that is capable of progressively optimizing its range resolution depending upon the target scattering features. It consists of a test-bed that enables the generation of linear frequency modulated waveforms of various bandwidths. This paper discusses a theoretical approach to optimizing the bandwidth used ...
متن کاملTracking Radar Digital Matched-Filter ASIC Design
Matched-filter is widely used in real time signal processing, especially in Radar Signal Processing. This paper provides a novel structure of digital matched-filter used in tracking radar system. This design applies block-floating-point arithmetic to improve the precision. The whole digital matched-filter is implemented in only one chip of FPGA. This ASIC has two work modes: 512 points pulse co...
متن کاملDesign and construction of a portable unite for measuring body-fluid components
Introduction: In the laboratory, the time required to measure body-fluids components is usually one to two working days. The laboratory methods require sample preparation and instrument cleaning after the sample reading. In emergency scenarios, the physician does not have much time to make a clinical decision. To solve these challenges, a portable system for measuring the body fluids components...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Glaciology
سال: 1989
ISSN: 0022-1430,1727-5652
DOI: 10.3189/002214389793701383