Design and Implementation of Single-Phase Boost PFC Converter
نویسندگان
چکیده
In this paper, a single-phase boost type ac-dc converter with power factor correction (PFC) technique is designed and implemented. A current mode control at constant switching frequency used as strategy for PFC converter. The single-stage singleswitch that uses shaping to reshape the non-sinusoidal input drawn by bulky capacitor in conventional rectifier. This should provide an almost free-harmonics, comply IEC61000-3-2 limits, system operates near unity factor. other function of beaccomplished regulated DC output voltage. complete simulated MATLAB/SIMULINK hardware prototype has been built using analog devices. Simulation results experimental are presented validate proposed system.
منابع مشابه
A Low Cost Single-Switch Bridgeless Boost PFC Converter
Received Jan 2, 2014 Revised Mar 12, 2014 Accepted Mar 25, 2014 This paper proposes the single-switch bridgeless boost power factor correction (PFC) converter to achieve high efficiency in low cost. The proposed converter utilizes only one active switching device forPFC operation as well as expecting higher efficiency than typical boost PFC converters. On the other hand, the implementation cost...
متن کاملDesign and real time implementation of single phase boost power factor correction converter.
This paper presents a real time implementation of the single-phase power factor correction (PFC) AC-DC boost converter. A combination of higher order sliding mode controller based on super twisting algorithm and predictive control techniques are implemented to improve the performance of the boost converter. Due to the chattering effects, the higher order sliding mode control (HOSMC) is designed...
متن کاملStarting strategies of three-phase single-stage PFC converter based on isolated full-bridge boost topology
Starting strategies were investigated for a three-phase single-stage power factor correction (PFC) converter. Starting process and mechanism of input over current was analyzed in detail. A lossy method was proposed and designed in which a resistor was connected in series with the filter capacitor to increase effective value of output voltage. Based on them, the boost inductors were replaced by ...
متن کاملFuzzy Sliding Mode Controlled Single Phase AC/DC Boost PFC Converter
. Abstract: This paper presents a Fuzzy sliding mode controller (FSMC) used as a control technique for a Single phase AC/DC boost PFC converter for achieving high power factor and regulated voltage. The controller possesses the merits of both fuzzy controller and variable structure controller. The considered controller has advantages such as robustness when there is a large line and load variat...
متن کاملDesign And Implementation Of PFC CUK Converter-Based PMBLDCM Drive
This method is used to improve the efficiency of motor drive by power factor correction. It plays an important role in energy saving during energy conversion. A cuk dc -dc converter topology reduced the power quality problems and improve the power factor at input ac mains. A three-phase voltage-source inverter is used as an electronic commutator operates the PMBLDCM drive The concept of voltage...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Ma?allat? al-handasat?
سال: 2023
ISSN: ['1726-4073', '2520-3339']
DOI: https://doi.org/10.31026/j.eng.2013.12.08