Design and Implementation of Medium Redundant Dual-network POWERLINK Communication Systems
نویسندگان
چکیده
منابع مشابه
Design and Practical Implementation of a New Markov Model Predictive Controller for Variable Communication Packet Loss in Network Control Systems
The current paper investigates the influence of packet losses in network control systems (NCS’s) using the model predictive control (MPC) strategy. The study focuses on two main network packet losses due to sensor to controller and controller to actuator along the communication paths. A new Markov-based method is employed to recursively estimate the probability of time delay in controller to ac...
متن کاملASIC Design of Butterfly Unit Based on Non-Redundant and Redundant Algorithm
Fast Fourier Transform (FFT) processors employed with pipeline architecture consist of series of Processing Elements (PE) or Butterfly Units (BU). BU or PE of FFT performs multiplication and addition on complex numbers. This paper proposes a single BU to compute radix-2, 8 point FFT in the time domain as well as frequency domain by replacing a series of PEs. This BU comprises of fused floating ...
متن کاملDesign and Implementation of Secure Chaotic Communication Systems
........................................................................................................................... i Acknowledgements ......................................................................................................... ii Declaration ..................................................................................................................... iii List of Fig...
متن کاملDesign and ASIC implementation of DUC/DDC for communication systems
Communication systems use the concept of transmitting information using the electrical distribution network as a communication channel. To enable the transmission data signal modulated on a carrier signal is superimposed on the electrical wires. Typical power lines are designed to handle 50/60 Hz of AC power signal; however they can carry the signals up to 500 KHz frequency. This work aims to a...
متن کاملDesign, Simulation and implementation of active dual-band dipole antenna using a series stub
In this paper, a new method for designing an active dual-band dipole antenna is proposed. The operating frequencies of the proposed antenna are 150 and 450 MHz that are usually used in military applications. Using a series stub is the main idea in the proposed dual-band antenna, where it makes an independent resonance frequency higher than the main resonance frequency of a conventional dipole. ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: DEStech Transactions on Engineering and Technology Research
سال: 2017
ISSN: 2475-885X
DOI: 10.12783/dtetr/iceea2016/6642