Design and implementation of a UWB six-port correlator for 6-9 GHz frequency band
نویسندگان
چکیده
منابع مشابه
Design and Implementation of an Ultra- Wideband Six-port Network
This paper presents a six-port network over an ultrawideband (UWB) of 2–8GHz. Its key component is the six-port junction, which consists of a Wilkinson power divider and three 3-dB quadrature couplers. This six-port junction is accomplished in a low dielectric constant substrate (Rogers RT/duroid 5880). Multi-section impedance transformation is applied in the power divider, and the quadrature c...
متن کاملA 6–12 GHz Analogue Lag-Correlator for Radio Interferometry
Aims. We describe a 6–12 GHz analogue correlator that has been developed for use in radio interferometers. Methods. We use a lag-correlator technique to synthesis eight complex spectral channels. Two schemes were considered for sampling the cross-correlation function, using either real or complex correlations, and we developed prototypes for both of them. We opted for the “add and square” detec...
متن کاملFrequency Triplexer for Ultra-Wideband Systems (6-9 GHz)
A triplexer for ultra-wideband radio implemented entirely with distributed microstrips is presented. The triplexer is composed of a triplex junction network and three bandpass filters. The circuit is integrated in a flex-rigid printed circuit board. Three flat 1 GHz sub-bands in the frequency band 6-9 GHz have been achieved. The group delay variation within each 1 GHz sub-band was measured to b...
متن کاملDesign and Implementation of a Constant Frequency Sliding Mode Controller for a Luo Converter
In this study, a robust controller for voltage regulation of the POESLL converter worked in continuous conduction mode is presented. POESLL converter is a DC/DC converter with a high voltage gain. DC/DC converters are used in telecommunication systems, power sources and industrial applications. Owing to the switching operation, the structure of the POESLL converter is highly non-linear. In addi...
متن کاملDesign and Fabrication of a 911 GHz Balanced Low Noise Amplifier Using HJFET
This paper describes the design of an X-band balanced low noise amplifier (LNA) using an available HJFET device. The balanced LNA consists of a pair of electrically similar transistors whose input and output signals are divided or combined by 3 dB two-stage Wilkinson power dividers. The proposed balanced LNA is fabricated and measured. The measured results show that the noise figure is 1.30 dB ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Microwave and Optical Technology Letters
سال: 2012
ISSN: 0895-2477
DOI: 10.1002/mop.27235