Design and Fabrication of Stepped Impedance Multi-Function Filter
نویسندگان
چکیده
منابع مشابه
Wideband Tri-band Filter Design using Stepped-impedance Stub Resonators
This letter presents a wideband tri-passband filter in which tri-section stepped-impedance shunt-stubs are used as tri-mode resonators, connected by transmission lines. Developed from the topology of quarter-wavelength stub filters, these filters have much wider passbands compared to many other designs published. The stepped-impedance stubs also contribute transmission zeros between the passban...
متن کاملDesign and Analysis of Stepped Impedance Microstrip Fractal Low Pass Filter
Most communication system contains an RF front end which performs signal processing with RF filters. Micro strip filters are a low cost means of doing this. This paper describes the design of low cost and low insertion loss microstrip stepped impedance Fractal low pass filter (LPF) by using microstrip layout which works at 0.4 GHz for permittivity 4.7 value with a substrate thickness 1.6 mm wit...
متن کاملDesign of a Band-pass Filter Using Stepped Impedance Resonators with Floating Con- Ductors
A new type of miniaturized stepped impedance resonator (SIR) for bandpass filter applications is proposed in this paper. The new resonator incorporates a ground plane window with a floating conductor in the backside of the substrate. The ground plane window increase the characteristic impedance of the lines used to implement the inductive region of the quasi-lumped resonator, thus allowing some...
متن کاملWideband Bandpass Filter Using Stepped Impedance Resonator with Susceptibility Test
A stepped impedance resonator (SIR) based wideband bandpass filter (BPF) with a good rejection level in the extended upper stopband is presented in this article. The proposed SIR is found to have the ability to introduce two transmission poles in the passband. By appropriately selecting the impedance ratio and length ratio (α) of the SIRs, the BPF can provide a wide passband and a sharp rejecti...
متن کاملDesign and Analysis of Multi-band Filters Using Slot Loaded Stepped Impedance Res- Onators
Two multi-band filters operating in the 1–10 GHz range are designed, analytically studied and experimentally verified. The filters are developed by making modifications to a series capacitively coupled, microstrip line filter. The middle section of the microstrip line is widened and rectangular slots are etched on it. Widening increases the effective dielectric constant which helps in miniaturi...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Electrical and Computer Systems
سال: 2018
ISSN: 1929-2716
DOI: 10.11159/ijecs.2018.001