Design and analysis of dual band pass filter
نویسندگان
چکیده
منابع مشابه
Analysis and Design of Dual-Band Planar Band Pass
This paper describes the design and analysis of planar dualband bandpass filters using stepped impedance resonators. In the proposed filter configurations, dual-band bandpass filters are designed, and realized by using inverted stepped impedance (SIR) resonators. The conventional half wavelength open circuited stub single frequency resonators are replaced with dual band simple two section stepp...
متن کاملDual-Band Evanescent-Mode Substrate Integrated Waveguide Band-pass Filter for WLAN Applications
A new multi-layer substrate integrated waveguide (SIW) structure is developed to design dual-band evanescent-mode band-pass filters (BPFs). Two independent series LC circuits are implemented by incorporating metallic irises in the different layers of the structure. The combination of the metallic irises with capacitive-plates is embedded inside the SIW to independently excite two evane...
متن کاملDesign of S-Band Interdigital Band Pass Filter
Abstarct: A Band Pass Filter is one of the key components in the receive chain of any Transmit-Receive Module of an Active Array Radar. The critical parameter for the design of a BPF for a TR module is the form factor,insertion loss and rejection. Hence a microstrip based interdigital (tapped) BPF for S-Band TR Module (3.1-3.5 GHz) was designed. The filter was designed to achieve a typical inse...
متن کاملDual-Band Band-Pass Filter with Fixed Low Band and Fluidically-Tunable High Band
In this work, we present a dual-band band-pass filter with fixed low-band resonant frequency and tunable high-band resonant frequency. The proposed filter consists of two split-ring resonators (SRRs) with a stub and microfluidic channels. The lower resonant frequency is determined by the length of the SRR alone, whereas the higher resonant frequency is determined by the lengths of the SRR and t...
متن کاملDesign and Analysis of Triple Notched Band Uwb Band Pass Filter Using Defected Microstrip Structure (Dms)
This paper presents design, simulation, fabrication and electrical analysis of a triple notched band UWB band pass filter. Short circuit stubs and microstrip line defected structures are used to design a triple notched band UWB filter. The proposed UWB BPF consists of five short circuited stubs of quarter wavelength attached to the feed line. The notched bands are created by introducing three U...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Sustainable Engineering and Innovation
سال: 2020
ISSN: 2712-0562
DOI: 10.37868/sei.v2i1.41