Design and analysis of a three stage CMOS op-amp using indirect feedback compensation
نویسندگان
چکیده
منابع مشابه
Two Stage Op - Amp Using Cmos – Areview
Operational Amplifier (op-amp) is a basic building block of many analog and mixed signal systems. Many different types of op-amp are used to achieve various functions, such as DC biasing, high speed amplifying, reduced voltage supply, high gain. To achieve these parameter successfully there are several techniques.The op-amp contains two stages to increase gain and improve slew rate, voltage swi...
متن کاملA Multistage Low Supply Op-Amp in 0.25μm CMOS using Modified Active-Feedback Frequency- Compensation
This paper presents the design, analysis, and simulated results of a three stage low power op-amp in a 0.25μm CMOS process technology. The op-amp overcomes the problems of cascading stages under low supply voltage by using modified active-feedback frequency compensation. This op-amp operates over a common-mode voltage (Vcm)from 0 to 0.6V, a supply voltage (Vdd) of 1.5V ±5%, a temperature range ...
متن کاملHigh Speed Op-amp Design: Compensation and Topologies for Two and Three Stage Designs
As CMOS technology continues to evolve, the supply voltages are decreasing while at the same time the transistor threshold voltages are remaining relatively constant. Making matters worse, the inherent gain available from the nano-CMOS transistors is dropping. Traditional techniques for achieving high gain by vertically stacking (i.e. cascoding) transistors becomes less useful in sub-100nm proc...
متن کاملDesign and Performance analysis of Low power CMOS Op-Amp
This paper proposes a low power CMOS operational amplifier which operates at 1.8 V power supply. The unique behavior of the MOS transistors in sub-threshold region not only allows a designer to work at low input bias current but also at low voltage. While operating the device at weak inversion results low power dissipation but dynamic range is degraded. Designing of two-stage Op-Amp is a multi-...
متن کاملFrequency Compensation of Two Stage Op-Amp using Triode Mode Compensation Stage
A frequency compensation technique for the improvement of unity gain bandwidth (UGB) and power supply rejection ratio (PSRR) of two stage operational amplifiers is presented in this paper. Performance of proposed op-amp is compared with classical miller compensated op-amp and op-amp proposed by G. Blakiewicz [13]. The technique exploits the triode mode operation of a MOSFET in the compensation ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Physics: Conference Series
سال: 2020
ISSN: 1742-6588,1742-6596
DOI: 10.1088/1742-6596/1706/1/012055