Depth Measurement of Materials Attached to Cylinder Using Line Laser
نویسندگان
چکیده
منابع مشابه
Residual Stresses Measurement of a Quenched Cylinder using Slitting Method
Residual Stress measurement has gained interests among researchers for many years due to its great influence on the structural integrity. Slitting method is one of the destructive techniques that relies on the introduction of an increasing cut to a part containing residual stresses. Similar to all other mechanical strain relief techniques, slitting also suffers from its shortcomings during the ...
متن کاملmorphology, geochemistry, mineralogy, and micromorphology of soils of hormozgan province in relation to parent materials
ویژگی های زمین شیمیایی، کانی شناسی، و میکرومورفولوژیکی خاک ها و سنگ مادر مربوطه در منطقه بین بخش های جنوبی زاگرس و خلیج فارس تا دریای عمان(استان هرمزگان، ایران) مورد بررسی قرار گرفت. هدف های این مطالعه شناسایی تغییرات در خصوصیات فیزیکی، شیمیایی، و ترکیب کانی شناسی خاک، مطالعه میکرومورفولوژی و تکامل خاک، و بررسی توزیع عنصر خاک بر اساس هوازدگی، پروسه های خاک و زمین شناسی جهت توصیف اثرات مواد مادر...
15 صفحه اولLine-focused laser ablation for depth-profiling analysis of coated and layered materials.
The performance features of line-focused laser ablation for the characterization of interfaces in layered materials by laser-induced plasma spectrometry (LIPS) have been compared with the point-focusing method in terms of signal precision, signal-to-noise ratio, ablation rates, and surface sensitivity. In both optical configurations a pulsed Nd:YAG laser beam operating at 532 nm, with a homogen...
متن کاملAnalysis of Flow Past a Cylinder Attached to a Spring
The flow of fluid past a cylinder has been widely studied both analytically and numerically, and provides insight to the behavior of flow given different fluid properties. Particularly interesting is the transition from steady flow to vortex shedding in the wake of the cylinder. This behavior is dependent on several parameters, but most importantly, the Reynolds number (Re), which is a dimensio...
متن کاملMeasurement of laser diode astigmatism using the beam-line method
Roland V. Shack University of Arizona Optical Sciences Center Tucson, Arizona 85721 Abstract. We propose a novel method to measure the astigmatism of laser diodes that is based solely on power measurements and does not require the use of any imaging system. Experimental realization of this method resulted in a sensitive measuring technique. Using it, a linear dependence of astigmatism change on...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Korea Multimedia Society
سال: 2017
ISSN: 1229-7771
DOI: 10.9717/kmms.2017.20.2.225