Deposition process of an epilam film during surface plastic deformation
نویسندگان
چکیده
منابع مشابه
Plastic Deformation Characteristics of Continuous Confined Strip Shearing Process Considering the Deformation Homogeneity and Damage Accumulation
In the present investigation, two dimensional elastoplastic finite element analysis was conducted to assess the deformation characteristics of Al 1100 alloy during continuous confined strip shearing (C2S2) process. The results of simulations showed that the plastic strain distribution across the deformed sample is non-uniform irrespective of the amount of friction and C2S2 die angle. The most u...
متن کاملcorrelation between twinning and surface rumpling phenomenon during plastic deformation of austenitic manganese steel
in this paper, the correlation between the surface rumpling and cracking phenomena with twinning mechanism during plastic deformation of hadfield steel has been investigated. the effect of stacking fault energy and the amount of strain are evaluated. the experimental samples with specific amounts of carbon, manganese and aluminum resulting in different stacking fault energies, were produced usi...
متن کاملFinite element analysis of elastic-plastic solids under Vickers indentation: surface deformation
Finite element modeling has been used to study the development of surface deformation during indentation with a Vickers indenter. A wide range of materials with different elastic modulus and yield stresses are examined. Results show that in a pyramidal indentation process, for a perfectly plastic material, sinking-in during loading can change to pile-up in unloading. This phenomenon depends on ...
متن کاملSaturation of surface roughening instabilities by plastic deformation
Surface roughening instabilities driven by a competition between elastic and surface energy contributions are shown to be saturated by plastic energy dissipation. It is shown that these morphological instabilities do not experience unbounded growth as predicted by consideration of elastic energy alone and that their growth is limited by dislocation emission from higher curvature grooves. © 2008...
متن کاملPLASTIC DEFORMATION BEHAVIOUR AT THE WORN SURFACE OF NOVEL CAST AL-ALLOY-TICP COMPOSITE
An AI-7wt%Si-5vol%TiCp was worn against a cast iron disc in a tri-pin-on-disc machine, under dry sliding conditions at the sliding speed of 0.24 m/s and applied loads of 6, 20 and 40 N/pin. Stress-strain (`3-^9) curves were constructed by measuring the microhardness and the equivalent strain gradients in near surface regions on the cross-sectional surface prepared parallel to sliding direction....
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IOP Conference Series: Materials Science and Engineering
سال: 2021
ISSN: 1757-899X
DOI: 10.1088/1757-899x/1029/1/012005