Depleted fully monolithic CMOS pixel detectors using a column based readout architecture for the ATLAS Inner Tracker upgrade
نویسندگان
چکیده
منابع مشابه
The Phase II ATLAS Pixel Upgrade: The Inner Tracker (ITk)
The entire tracking system of the ATLAS experiment will be replaced during the LHC Phase II shutdown (foreseen to take place around 2025) by an all-silicon detector called the ITk (Inner Tracker). The pixel detector will comprise the five innermost layers, and will be instrumented with new sensor and readout electronics technologies to improve the tracking performance and cope with the HL-LHC e...
متن کاملReadout of GEM Detectors Using the Medipix2 CMOS Pixel Chip
We have operated a Medipix2 CMOS readout chip, with amplifying, shaping and charge discriminating front-end electronics integrated on the pixel-level, as a highly segmented direct charge collecting anode in a three-stage gas electron multiplier (Triple-GEM) to detect the ionization from Fe X-rays and electrons from Ru. The device allows to perform moderate energy spectroscopy measurements (20 %...
متن کاملAn Optical Demo-Link for ATLAS Inner Detector Readout Upgrade
The GOL ASIC is a serializer chip developed by CERN based on a 0.25 μm CMOS technology [1]. The GOL operates with two data rates: 800 Mbps and 1.6 Gbps. This ASIC has been evaluated with radiation tolerance requirement for the ATLAS Inner Detector upgrade for the SLHC 1 . A demo-link has been designed and constructed to read out silicon detectors in the test staves through fiber optics. Through...
متن کاملCMOS Monolithic Active Pixel Sensors (MAPS) for future vertex detectors
This paper reviews the development of CMOS Monolithic Active Pixel Sensors (MAPS) for future vertex detectors. MAPS are developed in a standard CMOS technology. In the imaging field, where the technology found its first applications, they are also known as CMOS Image Sensors. The use of MAPS as a detector for particle physics was first proposed at the end of 1999. Since then, their good perform...
متن کاملDouble-sided Silicon Detectors using N-side Pad Readout for the CMS Silicon Inner Tracker
Double-sided silicon detector prototypes produced for the CMS inner tracker are described which divide the n-side into pads rather than strips. The signal routing to the readout electronics is made on a separate flexible z-print which is glued on the detector and then wire-bonded to the pads.
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of Instrumentation
سال: 2018
ISSN: 1748-0221
DOI: 10.1088/1748-0221/13/03/c03039