Densification of Powders by Particle Deformation

Enhanced densification of zinc powders through thermal cycling

The densification of zinc powders by uniaxial hot pressing is investigated under both isothermal and thermal cycling conditions. Thermal cycling results in enhanced densification kinetics as compared to isothermal compaction at the upper cycle temperature. Using mechanistic models of initial-stage powder densification, the experimental data are analyzed to reveal the creep stress-exponent and a...

Densification behaviour of metal powders at high temperature

Full densification of Molybdenum powders using Spark Plasma Sintering

Pure molybdenum powder was sintered using Spark Plasma Sintering under various temperatures, and holding times, under a pressure of 77 MPa and a heating rate at 700°C/min. After sintering, a carbide layer was observed at the surface. The carbide layer thickness, the relative density of the sample as well as the microhardness and the grain size of Mo were measured. The carbide thickness depends ...

Densification characteristics of chromia/alumina castables by particle size distribution

The quality of the refractories applied on integrated gasification combined cycle should be a key factor that affects both the reliability and the economics of gasifier operation. To enhance the workability of chromia/alumina castables, three types of ultrafine alumina powder were added to improve the workability. Densification behavior of such castables in the presence of ultrafine alumina was...

Successful Particle Size Analysis of Dry Powders

A correctly set up dry powder measurement using a laser diffraction particle size analyser is much easier to perform than measurement of wet suspensions. However, incorrect measurement set-up can lead to errors and inconsistencies. This article examines the key steps achieving successful dry to powder measurement. Issues examined include powder flowability and sampling, air pressure and sample ...