Densification Control in Hot Pressing of Metallic Glass Powders
نویسندگان
چکیده
منابع مشابه
Argon-shielded hot pressing of titanium alloy (Ti6Al4V) powders.
The paper presents the method of the argon - shielded hot pressing of titanium alloy (Ti6A14V) powder (used in medical industry). The powders produced in the GA (gas atomization) process and in the HDH (hydride - dehydride) process were used in the experiments. A pressing process was conducted at a temperature of 800-850 degrees C for different lengths of time. An unoxidized sintered material, ...
متن کاملMg–Y–Cu bulk metallic glass prepared by mechanical alloying and vacuum hot-pressing
We have studied the amorphization behavior of Mg85KxY15Cux (xZ20–40) alloy powders synthesized by mechanical alloying technique. The as-milled powders were mainly amorphous after 10 h of milling. The thermal stability of these Mg85KxY15Cux glassy powders was investigated by differential scanning calorimeter (DSC). The ranges of Tg, Tx and DTx are around 430–459, 467–497, and 30–46 K, respective...
متن کاملHardness and Densification Behaviour of Copper and Bronze Powders Compacted with Uniaxial Die and Cold Isostatic Pressing Processes
A. Eksi, Faculty of Engineering and Architecture, Çukurova University, Adana, Turkey, M. K. Kulekci, Faculty of Technical Education, Mersin University, Tarsus, Turkey In this study hardness and densification behaviour of copper and bronze powders under wet bag cold isostatic and uniaxial die pressing processes are examined. In uniaxial pressing the specimens were compacted up to a pressure of 8...
متن کاملHot embossing of micro-lens array on bulk metallic glass
Hot embossing of micro-lens array on bulk metallic glass C.T. Pan a,∗, T.T. Wu a, M.F. Chen a, Y.C. Chang b, C.J. Lee b, J.C. Huang b a Department of Mechanical and Electro-Mechanical Engineering, and Center for Nanoscience & Nanotechnology, National Sun Yat-Sen University, Kaoshiung 804, Taiwan, ROC b Institute of Materials Science & Engineering, Center for Nanoscience and Nanotechnology, Nati...
متن کاملThe Effect of Powder Mixing Procedures on α- SiAlON
Various procedures of mixing starting powders for hot-pressing α-SiAlON ceramics were studied. They included different milling methods (attrition milling, ball milling, and sonication), liquid medium (water, isopropyl alcohol, and pyridine), and atmospheres (ambient air and nitrogen). These mixing procedures resulted in markedly different densification behavior and fired ceramics. As the powder...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society of Powder and Powder Metallurgy
سال: 2008
ISSN: 0532-8799,1880-9014
DOI: 10.2497/jjspm.55.709