Delicacy Management on Kiloton Dry Wet Spinning Bath Liquid
نویسندگان
چکیده
منابع مشابه
Sliding friction on wet and dry sand.
We show experimentally that the sliding friction on sand is greatly reduced by the addition of some-but not too much-water. The formation of capillary water bridges increases the shear modulus of the sand, which facilitates the sliding. Too much water, on the other hand, makes the capillary bridges coalesce, resulting in a decrease of the modulus; in this case, we observe that the friction coef...
متن کاملSliding Friction on Wet and Dry Sand
Disclaimer/Complaints regulations If you believe that digital publication of certain material infringes any of your rights or (privacy) interests, please let the Library know, stating your reasons. In case of a legitimate complaint, the Library will make the material inaccessible and/or remove it from the website. Please Ask the Library: http://uba.uva.nl/en/contact, or a letter to: Library of ...
متن کاملInvestigating the Spinnability in the Dry-Jet Wet Spinning of PAN Precursor Fiber
The spinnability of a spinning solution using DMSO as the solvent was investigated for dry-jet wet spinning of PAN precursor fiber. Among many variables responsible for spinnability, the coagulating conditions, the air gap length, the nonsolvent content in spinning solution, and the spinning temperature have been viewed as the key factors, and they were investigated in this study. It was found ...
متن کاملAre Dry Mergers Dry, Moist, or Wet?
We present a spectral analysis of a sample of red-sequence galaxies identified by van Dokkum (2005) as dry merger remnants and ongoing dry mergers. Kinematics, stellar population absorption features, and ionisation from emission lines, are derived. We find that approximately half of the sample showing strong tidal features have younger stellar populations than a control sample at a given veloci...
متن کاملFabrication of κ-Carrageenan Fibers by Wet Spinning: Spinning Parameters
This study demonstrates the fabrication of κ-carrageenan fibers by a wet-spinning method and discusses three important spinning parameters: coagulation bath composition, spinning rate and post-spinning mechanical drawing. The as-spun fiber diameter decreased with KCl and ethanol concentration in the coagulation bath. In general, the ultimate tensile stress and elongation at break both increased...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal of Materials Science and Applications
سال: 2021
ISSN: 2327-2635
DOI: 10.11648/j.ijmsa.20211001.13