Degradation in PZT Ceramics after Applying a Large Pulsed Input Power.
نویسندگان
چکیده
منابع مشابه
ERRATUM Power harvesting with PZT ceramics and circuits design
Power generated from a piezoelectric material usually comes with poor characteristics such as high voltage, low current and high impedance. In order to drive the embedded sensor circuit, piezoelectric power needs to be characterized and regulated. In this paper, we present an analysis on the power generation characteristics and the efficiency of power conversion of the stiff lead zirconate tita...
متن کاملCompatibility of RuO2 electrodes with PZT ceramics
Because of its high electrical conductivity and good diffusion barrier properties ruthenium dioxide (RuO2) is a good electrode material for use with ferroelectric lead zirconate–titanate (PZT) solid solutions. Under certain conditions, RuO2 can react with PZT to form lead ruthenate (Pb2Ru2O6⋅5) during processing at elevated temperatures resulting in lead depletion from PZT. The standard Gibbs e...
متن کاملSynthesis and Processing of Ferroelectric Pzt Powders, Ceramics and Films
In this chapter, various synthesis routes for PZT powders and fabrication processing techniques for PZT ceramics and films are reviewed. Emphasis is placed on chemical routes, especially the hydrothermal synthesis of PZT powders. The principles of the colloidal chemistry in ceramic suspension and its application to the colloidal processing of ceramics and films, especially when using sub-micron...
متن کاملLow-temperature sintering of MnO2-doped PZT–PZN Piezoelectric ceramics
The effect of MnO2 addition on the microstructural evolution and piezoelectric properties of low temperature sinterable PZT–PZN ceramics was investigated. When a small amount of MnO2 (≤0.5 wt% ) was added, the Mn ions were homogeneously dissolved in the PZT– PZN ceramics, leading to full densification at a temperature as low as 930 °C. However, the further addition of MnO2 hindered the densific...
متن کاملMOSFET degradation dependence on input signal power in a RF power amplifier
Aging produced by both DC and RF stress is experimentally analyzed on a RF CMOS power amplifier. The selected circuit topology allows observing individual NMOS and PMOS transistors degradations, as well as the aging effect on the circuit functionality. A direct relation between DC and RF (gain) parameters has been observed. NMOS degradation (both in mobility and Vth) is stronger than that of th...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society of Powder and Powder Metallurgy
سال: 2001
ISSN: 0532-8799,1880-9014
DOI: 10.2497/jjspm.48.796