Deformations of Ti-6Al-4V additive-manufacturing-induced isotropic and anisotropic columnar structures: Insitu measurements and underlying mechanisms
نویسندگان
چکیده
منابع مشابه
Process Mapping, Fracture and Fatigue Behavior of Ti-6al-4v Produced by Ebm Additive Manufacturing
The present work was conducted as part of a larger America Makes funded project to begin to examine the effects of changes in process variables on the resulting microstructure and fracture and fatigue behavior of as-deposited Ti-6Al-4V. In addition to presenting initial results on process mapping of the electron beam powder bed process, the present work also documents the location-dependent pro...
متن کاملPROCESS CONTROL AND DEFECTS IN Ti-6Al-4V ADDITIVE MANUFACTURING, USING PLASMA TRANSFERRED ARC (PTA) TECHNIQUES
Defects during Plasma Transfer Arc (PTA) beam fusion additive manufacturing (AM) processing of Ti-6Al-4V, including lack of fusion, porosity variations, and solidification cracking, have been monitored using near infrared (1.62 μm) imagery at 300 Hz, 300 μm spatial resolution and melt pool sizes of greater than 12μ. The temperature evolution exhibits a periodic temperature modulation of more th...
متن کاملInnovative Process Model of Ti-6al-4v Additive Layer Manufacturing Using Cold Metal Transfer (cmt)
New approaches to modern manufacture have emerged from Additive Layer Manufacturing (ALM) technologies over the last 25 years. These approaches provide form, fit and function to a wide range of metallic alloys and components. Wire + Arc Additive Layer Manufacture (WAALM) has gained the interest of the research community in recent years due to its high deposition rate and efficiency (100%). The ...
متن کاملAdditive Manufacturing Laser Deposition of Ti-6Al-4V for Aerospace Repair Applications
Parts or products from high performance metal are very expensive, partly due to the processing complexities during manufacturing. The purpose of this project is to use additive laser deposition and machining processes to repair titanium parts, thus extending the service life of these parts. The study broadly included preparing the defects, laser deposition, machining, sample preparation and mec...
متن کاملFatigue of Ti-6Al-4V
Metallic biomaterials have essentially three fields of use; these are the artificial hip joints, screw, plates and nails for internal fixation of fractures, and dental implants. Any of these devices must support high mechanical load and resistance of material against breakage is essential. High mechanical properties are needed for structural efficiency of surgical and dental implants. But their...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Additive Manufacturing
سال: 2020
ISSN: 2214-8604
DOI: 10.1016/j.addma.2020.101322