Deformation Texture of Heavily Rolled Copper Sheet
نویسندگان
چکیده
منابع مشابه
Development of a strong Goss texture during annealing of a heavily rolled Al–0.3% Cu alloy
The evolution of microstructure and texture during isochronal annealing of a heavily cold rolled Al–0.3% Cu alloy has been characterized using electron backscatter diffraction. It is found that the rolling texture of this alloy is dominated by the Brass component and that recrystallization during annealing leads to the formation of a pronounced Goss texture. It is suggested that the development...
متن کاملEvolution of microstructure and texture during recovery and recrystallization in heavily rolled aluminum
The annealing behavior of nanostructured aluminum AA1050 prepared by cold rolling to an ultrahigh strain (vM = 6.4) has been investigated using both transmission electron microscopy and electron backscatter diffraction techniques, paying particular attention to changes in microstructure and texture during recovery and their influence on subsequent recrystallization. It is found that coarsening...
متن کاملEffect of strain rate on deformation texture in OFHC copper
A strong strain rate dependence on the crystallographic texture of oxygen-free high conductivity copper is observed and reported for the first time. Two shear compression specimens were deformed at widely different strain rates (0.001 s 1 and 7000 s ) to the same strain, and their textures were determined using orientation image microscopy. By comparing the stress–strain curves and the major te...
متن کاملStatistical analysis on static recrystallization texture evolution in cold-rolled AZ31 magnesium alloy sheet.
Cast AZ31B-H24 magnesium alloy, comprising Mg with 3.27 wt% Al and 0.96 wt% Zn, was cold rolled and subsequently annealed. Global texture evolutions in the specimens were observed by X-ray diffractometry after the thermomechanical processing. Image-based microstructure and texture for the deformed, recrystallized, and grown grains were observed by electron backscattered diffractometry. Recrysta...
متن کاملVanadium in Cold-rolled Sheet Steels
In hot rolled products, which are the subject of other presentations here, vanadium has been used for many years in high strength products, often in combination with other microalloying additions such as niobium or titanium. Vanadium can provide important contributions via both precipitation strengthening and ferrite grain refinement (due to austenite conditioning during thermomechanical proces...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Institute of Metals and Materials
سال: 1964
ISSN: 0021-4876,1880-6880
DOI: 10.2320/jinstmet1952.28.9_555