Deformation Mechanism of Hot Finish Rolling of Plastic Gears
نویسندگان
چکیده
منابع مشابه
Plastic-deformation mechanism in complex solids.
In simple crystalline materials, plastic deformation mostly takes place by the movement of dislocations. Although the underlying mechanisms in these materials are well explored, in complex metallic alloys--crystalline solids containing up to thousands of atoms per unit cell--the defects and deformation mechanisms remain essentially unknown. Owing to the large lattice parameters of these materia...
متن کاملDynamic Recrystallization by Necklace Mechanism During Hot Deformation of 316 Stainless Steel
The aim of this study is to investigate the nucleation of new grains by necklacing mechanism during dynamic recrystallization (DRX). The material used is 316 stainless steel. In order to modeling the deformation behavior during hot rolling, one-hit compression tests were performed at temperature range of 950-1100 °C with strain rates of 0.01-1s-1. The result shows that at the tempera...
متن کاملAnalysis of Internal Crack Healing Mechanism under Rolling Deformation
A new experimental method, called the 'hole filling method', is proposed to simulate the healing of internal cracks in rolled workpieces. Based on the experimental results, the evolution in the microstructure, in terms of diffusion, nucleation and recrystallisation were used to analyze the crack healing mechanism. We also validated the phenomenon of segmented healing. Internal crack healing inv...
متن کاملEstimation of lifetime for plastic gears
The importance of plastic gears for modern industry is growing every year. The engineer sizing plastic gears has a very difficult task. There is no international standard available for the strength analysis. The only method publicly accepted is the German guideline VDI2545. In addition to a lack of calculation methods there is a need for measuring material properties. This paper shall give an o...
متن کاملMagnificent Grain Refinement of Al-Mg2Si Composite by Hot Rolling
The effect of chemical composition and the hot rolling operations on the microstructure and mechanical properties of in situ aluminum matrix composite with Mg2Si phase as the reinforcement was studied. It was revealed that the modification by phosphorous results in the rounder (more spherical) primary and secondary (eutectic) magnesium silicide intermetallics. During hot rolling, the primary pa...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: JSME international journal. Ser. C, Dynamics, control, robotics, design and manufacturing
سال: 1995
ISSN: 1340-8062
DOI: 10.1299/jsmec1993.38.312