Deformation Induced Surface Roughening of Austenitic Stainless Steels
نویسندگان
چکیده
منابع مشابه
Low-Temperature Carburization of Austenitic Stainless Steels
LOW-TEMPERATURE CARBURIZATION is a gaseous carburization process performed at atmospheric pressure, at temperatures where the kinetics of substitutional diffusion are very slow. Low-temperature carburization hardens the surface of austenitic stainless steels through the diffusion of interstitial carbon, without the formation of carbides. The surface must be activated, by modification and remova...
متن کاملDevelopment of Alumina-Forming Austenitic Stainless Steels
This paper presents the results of the continued development of creep-resistant, alumina-forming austenitic (AFA) stainless steel alloys, which exhibit a unique combination of excellent oxidation resistance via protective alumina (Al2O3) scale formation and high-temperature creep strength through the formation of stable nano-scale MC carbides and intermetallic precipitates. Efforts in fiscal ye...
متن کاملY Studies on Austenitic Stainless Steels
Abstract--In this investigation, the fracture surfaces of SS 304 and SS 316 austenitic steels were analysed using the X-ray fractography technique. In both cases, a decrease in the austenite content was observed at the fracture surface as a result of deformation induced martensite, indicating a linear relation with Km~ within the stable crack growth region. The presence of this martensite was f...
متن کاملNeural network model of creep strength of austenitic stainless steels
The creep rupture life and rupture strength of austenitic stainless steels have been expressed as functions of chemical composition, test conditions, stabilisation ratio, and solution treatment temperature . The method involved a neural network analysis of a vast and general database assembled from published data. The outputs of the model have been assessed against known metallurgical trends an...
متن کاملAnalysis of deformation induced martensitic transformation in stainless steels
Many studies monitoring the formation of martensite during the tensile deformation of austenite report data which are, in principle, affected by both the applied stress and the resulting plastic strain. It is not clear in these circumstances whether the transformation is stress induced (i.e. the stress provides a mechanical driving force) or whether the generation of defects during deformation ...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: ISIJ International
سال: 2003
ISSN: 0915-1559
DOI: 10.2355/isijinternational.43.1795