Deformation Behavior of High-Mn TWIP Steels Processed by Warm-to-Hot Working
نویسندگان
چکیده
منابع مشابه
Corrosion Behaviour of High-Mn TWIP Steels with Electroless Ni-P Coating
An attempt has been taken to improve the corrosion resistance of twinning-induced plasticity (TWIP) steels (Fe-25Mn and Fe-25Mn-3Al) by electroless Ni-P coating. Corrosion resistance in 3.5% NaCl and 0.1M H2SO4 solutions was characterized by the potentiodynamic polarization curves and Tafel method calculations. It was found that Ni-P coating improved the corrosion resistance by the factor of 4 ...
متن کاملInfluence of Initial Microstructure on Hot Deformation Behavior of Duplex Stainless Steels
In this research the effect of initial microstructure on hot deformation behavior in terms of Ferrite-to-Austenite ratios is studied. Two types of stainless steels C1 and C2 were homogenizing heat-treated and deformed under hot compression examinations at temperatures 900ºC and 1100ºC at strain rate of 0.1s-1. The results showed that the flow stress levels of specimens are strongly r...
متن کاملeffect of ai on the hot deformation of ferrite in cu-mn steels.
effect of small al additions, from 0.14% to 0.31% ai, on the hot deformation behavior of low carbon steels containing 1%cu-1.2%mn was investigated in the temperature range of 750-800•c over the strain rate range of 1o.3.1o.1s•1 by a hot compression testing machine. the flow curves obtained, exhibited typical characteristics of dynamic recovery type of softening mechanism, and the critical strai...
متن کاملStacking Fault Energy and Microstructural Insight into the Dynamic Deformation of High-Manganese TRIP and TWIP Steels
The dynamic behavior of three high manganese steels with very different stacking faultenergy (SFE) values (4-30 mJ/m2) were studied using high strain rate torsional tests. The hotrolledmicrostructure of the steel with the lowest SFE of 4 mJ/m2 consisted of a duplex mixture ofaustenite and ε-martensite, but those of the other two steels were fully austenitic. The deformedmicrostructures were stu...
متن کاملHot Deformation Behavior of Haynes 25 by the Hot Tensile Test
In the present work, hot tensile behavior of Haynes 25 Co-base alloy was investigated in the temperature range of 950-1200 ˚C and 0.1 s-1. Thermodynamic calculations showed that M23C6 and M6C carbides were stable below 1000 ˚C and above 1050 ˚C, respectively. Stress-strain curves also indicated an unusual trend of strain fracture. It was observed that with increasing temperature from 950 to 105...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Metals
سال: 2018
ISSN: 2075-4701
DOI: 10.3390/met8060415