Deformation at continuous forming of longitudinal welded pipes
نویسندگان
چکیده
منابع مشابه
Analysing of Continuous Welded Turnouts
Continuous welded turnouts are important for CWR track through the railway station. According to equivalent resistance and non-linear theories and the principle of force diagram, a new method of theoretical calculation for continuous welded turnouts was developed. The continuous welded turnouts designed and installed according to the new theory behaved fairly well. The data collected on sites b...
متن کاملAnalysing of Continuous Welded Turnouts
Continuous welded turnouts are important for CWR track through the railway station. According to equivalent resistance and non-linear theories and the principle of force diagram, a new method of theoretical calculation for continuous welded turnouts was developed. The continuous welded turnouts designed and installed according to the new theory behaved fairly well. The data collected on sites b...
متن کاملHealth Monitoring of Welded Steel Pipes by Vibration Analysis
In the present work, structure health monitoring (SHM) of welded steel pipes was used to diagnosis their state via vibration based damage detection techniques. The dynamic quantities such as Frequency Response Functions (FRFs), mode shapes and modal parameters from structural vibration to detect damage were measured, set on linear averaging mode, with a maximum frequency of analysis of 3.2 kHz....
متن کاملCold End Forming Of Welded Steel Tubes
The production of custom and specific tube end shapes by cold end forming using a die is generally limited to seamless tubular parts. Current research work in the field follows the same trend as that of industry and, therefore, there is no accumulated experience, no practical design rules, and no information available in the specialized literature concerning the utilization of tube end forming ...
متن کاملInvestigation on Formability of Tailor-Welded Blanks in Incremental Forming
Steel laser tailor-welded blanks (TWBs) are produced by end-to-end joining of base sheets using different welding methods. In this article, the formability of laser TWBs of St12 and St14 with thicknesses of 1 mm and 1.5 in single point incremental forming process were experimentally and numerically investigated. First, the forming limit wall angle was experimentally determined for each of the b...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Izvestiya. Ferrous Metallurgy
سال: 2021
ISSN: 2410-2091,0368-0797
DOI: 10.17073/0368-0797-2021-1-21-27