Deformation aspects of anisotropic-porous bodies sintering

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Theory of Deformation of a Porous Viscoelastic Anisotropic Solid

Equations are established for the deformation of a viscoelastic porous solid containing a viscous fluid under the most general assumptions of anisotropy. The particular cases of transverse and complete isotropy are discussed. General solutions are also developed for the equations in the isotropic case. As an example the problem of the settlement of a loaded column is treated. The second-order e...

متن کامل

Finite element simulation of pyroplastic deformation, anisotropic shrinkage and heterogeneous densification for ceramic materials during liquid phase sintering process

Pyroplastic deformation is a distortion of the ceramic shape during the sintering process. It occurs because the flow of the vitreous phase at high temperature and the applied stress due to the weight of the product during sintering process. The aim of this paper deals with describing a numerical-experimental method to evaluate the pyroplastic deformation, to predict the anisotropic shrinkage a...

متن کامل

Complex-Shaped Porous Cu Bodies Fabricated by Freeze-Casting and Vacuum Sintering

Porous Cu bodies with complex shapes were fabricated by freeze-casting and vacuum sintering water-based CuO slurry. The sintered bodies showed no noticeable macroscopic defects and good shape tolerance. The interconnected pore tunnels were observed by electronic microscopy. The pore size became smaller and the porosity and volume shrinkage of sintered porous bodies decreased with the increase o...

متن کامل

On Analysis of Stress Concentration in Curvilinear Anisotropic Deformable Continuum Bodies

In cylindrical continua, hoop stresses are induced due to the circumferential failure. This mainly happens when the cylinder is subjected to mechanical loads which vary in the circumferential directions. On the other hand, radial stress is stress in the direction of or opposite to the central axis of a cylindrical body. In the present study, the influence of curvilinear anisotropy on the radial...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Le Journal de Physique IV

سال: 1993

ISSN: 1155-4339

DOI: 10.1051/jp4:19937117