Deformation and Strength of End Fillet Welds
نویسندگان
چکیده
منابع مشابه
Experimental Study on Strength and Ductility of Underwater Fillet Welds in Repairing Offshore Steel Structures
Underwater wet welding is one of the most common repair measures for corroded offshore steel structures. Few studies have been carried out systematically concerned with mechanical properties of such welds, thus current design provisions rely heavily on limited experimental data on welds made underwater and design properties for corresponding welds made in air. This paper presents a series of ex...
متن کاملThe Fatigue Strength of Fillet Welded Connections
This report describes a study of the fatigue behavior of fillet welded joints stressed perpendicular to the weld line. The study included an experimental phase in which the stiess-life and cracking behavior of load and nonload carrying fillet weld joints was determined. This experimental study concentrated on the fatigue behavior in the transition region between high and low cycle fatigue 3 5 (...
متن کاملDeformation and strength anisotropy of calcareous slates under Brazilian tests
Rock anisotropy plays an important role in engineering behavior of rocks. Slates are anisotropic rocks which have long been used for gable roof, floor tiles, borrow materials, and other purposes. The slates studied in this research are calcareous and have a porphyro-lepidoblastic texture. To determine the role of the anisotropy on the tensile strength and fracture pattern, two variables includi...
متن کاملThe effect of spring restraint on weld distortion in t-joint fillet welds
T-joint fillet welds are a very common occurrence found in industry today. Localized heating and cooling from the welding process lead to the rise of distortion and residual stresses. Weld fixturing is a common practice in industry used to address the problems associated with welding, however fixturing also creates problems of residual stresses being locked into the weldment. This research invo...
متن کاملFatigue Strength of Fillet-Welded Transverse Stiffeners with Undercuts
Presently, wrapping of the welds at the ends of stiffeners is not done to avoid the undercutting of the stiffener corners and the attendant weld repair. The fatigue performance of stiffeners with undercuts was evaluated in a factorial design fatigue experiment. Undercuts at the flange edge and filling of the stiffener cope with the fillet weld were also evaluated. The undercuts did not influenc...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Welding Society
سال: 1965
ISSN: 0021-4787,1883-7204
DOI: 10.2207/qjjws1943.34.417