Deformation and Damage Accumulation in a Ceramic Composite under Dynamic Loading
نویسندگان
چکیده
منابع مشابه
Fatigue Damage and Lifetime of SiC/SiC Ceramic-Matrix Composite under Cyclic Loading at Elevated Temperatures
In this paper, the fatigue damage and lifetime of 2D SiC/SiC ceramic-matrix composites (CMCs) under cyclic fatigue loading at 750, 1000, 1100, 1200 and 1300 °C in air and in steam atmosphere have been investigated. The damage evolution versus applied cycles of 2D SiC/SiC composites were analyzed using fatigue hysteresis dissipated energy, fatigue hysteresis modulus, fatigue peak strain and inte...
متن کاملDeformation mechanisms and damage in -alumina under hypervelocity impact loading
impact loading Cheng Zhang, Rajiv K. Kalia, Aiichiro Nakano, Priya Vashishta, and Paulo S. Branicio Collaboratory for Advanced Computing and Simulations, Department of Chemical Engineering and Materials Science, Department of Physics and Astronomy, and Department of Computer Science, University of Southern California, Los Angeles, California 90089-0242, USA Departmento de Física, Universidade F...
متن کاملDamage Evolution in Composite Bonded Joints under Fatigue Loading
The fatigue behaviour of single lap bonded joints under fatigue loading was already investigated and a suitable life prediction model was presented and validated [1-2]. The model is based on the actual damage evolution under fatigue load: a crack initiation followed by its propagation up to a critical length [2, 3]. In the present paper the evolution of fatigue damage in single lap joints is ex...
متن کاملPlastic Deformation Characteristics of Continuous Confined Strip Shearing Process Considering the Deformation Homogeneity and Damage Accumulation
In the present investigation, two dimensional elastoplastic finite element analysis was conducted to assess the deformation characteristics of Al 1100 alloy during continuous confined strip shearing (C2S2) process. The results of simulations showed that the plastic strain distribution across the deformed sample is non-uniform irrespective of the amount of friction and C2S2 die angle. The most u...
متن کاملDynamic Recrystallization under Hot Deformation of a PH Stainless Steel
Dynamic recrystallization, DRX, behaviour of a precipitation hardened, PH, stainless steel was studied in connection with microstructural developments in a compression test. The experimental results showed that the dominant mechanism of softening is DRX, but at high strain rates and low temperatures, ie, high Zener-Holman parameter, Z, work hardening and dynamic recovery, DRV, produced a pancke...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: IOP Conference Series: Materials Science and Engineering
سال: 2016
ISSN: 1757-8981,1757-899X
DOI: 10.1088/1757-899x/112/1/012044