منابع مشابه
Superplastic hemispherical Bulge Forming of a Ti-Al-Mn Alloy
Superplastic sheet thermoforming has been identified as a standard processing route for the production of complex shapes, especially in the aerospace industry. Ti-Al-Mn (OT4-1) alloy is currently being used for aero engine components as well as other aerospace applications by forming through a conventional route which is typically cost, labour and equipment intensive. The Ti-Al-Mn alloy (made a...
متن کاملAchieving microstructures prone to superplastic deformation in an Al - Zn - Mg - Cu alloy by equal channel angular pressing
An Al-Zn-Mg-Cu alloy without Sc or Zr additions was subjected to overaging and processing by equal channel angular pressing, obtaining a grain size of ∼160 nm and a fraction of high-angle boundaries of 56%. The high elongations attained at high strain rate (10-10 s) and low test temperature (250-300 oC) are attributed to the formation of new recrystallized grains, ∼500 nm in size, during heatin...
متن کاملDAMPING CAPACITY AND MECHANICAL PROPERTIES OF Zn-Al ALLOY CASTINGS
This paper describes damping capac i t y and mechanical p roper t ies o f Zn-8-20%A1 and Zn-8-20%Al-0.02-0.04XMg a l l o y cast ings. Zn-8-20%A1 a l l o y casti ngs show h igh damping when quenched from 573K. Small amount o f Mg a d d i t i o n t o these a l l o y cast ings lowers damping capaci ty considerably b u t e f f e c t i v e t o reduce decomposition through aging a t 423K f o r 48hrs ...
متن کاملExperimental and Numerical Investigation of Warm Deep Drawing Process of AA5052 Aluminum Alloy
Aluminum alloys have a high strength-to-weight ratio and proper anti-corrosion properties that are used in the automotive, shipbuilding and aerospace industries. The major problem with forming aluminum sheets is the low formability of aluminum sheets at room temperature. Therefore, in the present study, warm deep drawing (WDD) of AA5052-O aluminum alloy sheets with a thickness of 1mm was invest...
متن کاملSuperplastic Forming of Inconel Alloy 718spf
Superplasticforming (SPF) has become an important manufacturing method for aerospace and fuselage components. The basic reasons for the popularity of this process are reviewed and the compatibilityoffine-grained INCONELB alloy71 8SPF@ to superplasticforming are presented in this paper. The temperature limitations of current aluminum and titanium alloys employed in SPF parts for gas turbine comp...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Institute of Metals and Materials
سال: 1972
ISSN: 0021-4876,1880-6880
DOI: 10.2320/jinstmet1952.36.11_1081