منابع مشابه
An Investigation into the Deep Drawing of Fiber-Metal Laminates based on Glass Fiber Reinforced Polypropylene
Abstract Fiber-metal laminates (FMLs) are new type of composite materials which could improve defects of traditional composites in ductility, formability, impact and damage tolerance. Drawing behavior of a thermoplastic based FML was investigated consisting of glass-fiber reinforced polypropylene composite laminate and aluminum AA1200-O as the core and skin layers, respectively. The effects o...
متن کاملIncreasIng the deep drawabIlIty of al-1050 alumInum sheet usIng multI-poInt blank holder
The deep drawing is a process for shaping flat sheets into cup-shaped articles without failure or excessive localized thinning. The design and control of a deep drawing process depends not only on the material, but also on the condition of the tool material interface, the mechanics of plastic deformation, the equipment used, and the control of metal flow. The equipment and tooling parameters th...
متن کاملEffect of elevated temperatures on the drawability of aluminium sheet components
Because of the need for weight reduction in transport industry, in order to save energy as well as to reduce CO2-emission, the use of light weight aluminium sheet is taken increasingly into consideration [1]. But although aluminium is lighter than steel, the formability is less, hence press operations are often more critical. Alloys used are typically 5xxx alloys for inner panels because of the...
متن کاملAnalytical Modeling of Axi-Symmetric Sheet Metal Forming
The cup drawing is a basic deep drawing process. Thus, understanding the mechanics ofthe cup drawing process helps in determining the general parameters that affect the deep drawingprocess. There are mainly two methods of analysis; experimental and analytical/numerical.Experimental analysis can be useful in analyzing the process to determine the process parameters thatproduce a defect free prod...
متن کاملPrediction of Instability in Planar Anisotropic Sheet Metal Forming Processes
In this paper instability of planar anisotropic sheet metal during a few forming processes is investigated for the first time. For this reason components of the constitutive tangent tensor for planar anisotropic sheets are developed. By using the above tensor location of necking is predicted. Direction of the shear band is also predicted using the acoustic tensor. A finite element program is pr...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: TRANSACTIONS OF THE JAPAN SOCIETY OF MECHANICAL ENGINEERS Series A
سال: 1998
ISSN: 0387-5008,1884-8338
DOI: 10.1299/kikaia.64.1397