Decarburisation Effect on Hardened Strip Steel Fastening Components
نویسندگان
چکیده
منابع مشابه
Copper Precipitation Hardened, High Strength, Weldable Steel
Steel containing 0.03% carbon, 1.35% copper and 0.84% nickel had yield strength in the 540-625 MPa (78-90 Ksi) range depending on thickness, ultimate tensile strength in the 625-690 MPa (90100 Ksi) range, and 25-30% elongation when air cooled after hot rolling. No brittle heat-affected zone was formed during manual or automatic submerged arc welding without pre-heating or postheating. The fract...
متن کاملFinite Element Analysis of Hardened Steel Cutting
Hard machining, as attractive replacement for many rough and finish grinding operation, generates high cutting forces and temperature that enhance tool wear when act together. Therefore, the tool geometry and machining parameters have to be carefully optimized for a given material. Because of high cost and time consuming experimental work up-to-date advanced software for modeling and simulation...
متن کاملOn machining of hardened AISI D2 steel with PCBN tools
This paper describes an experimental investigation on machining of a difficult-to-cut material, AISI D2 steel of hardness 62 HRC with PCBN tools. It was found that the most feasible feeds and speeds fall in the ranges 0.08–0.20 mm/rev and 70–120 m/min, respectively and that most of the tested PCBN tools reached the end of life mainly due to flank wear. The highest acceptable values of tool life...
متن کاملExperimental Study of the Cutting Parameters Effect on Hole Making Processes in Hardened Steel
Hardened steels are commonly used in wide areas of technologies and industries. In respect of poor machinability of these steels and requirement of expensive cutting tools, study of machining economy is a matter of importance. Thus the present study deals with the economic considerations of various hole making processes. For this purpose, the hard steel samples were machined by conventional dri...
متن کاملExperimental Study of the Cutting Parameters Effect on Hole Making Processes in Hardened Steel
Hardened steels are commonly used in wide areas of technologies and industries. In respect of poor machinability of these steels and requirement of expensive cutting tools, study of machining economy is a matter of importance. Thus the present study deals with the economic considerations of various hole making processes. For this purpose, the hard steel samples were machined by conventional dri...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Materials Science
سال: 2016
ISSN: 2029-7289,1392-1320
DOI: 10.5755/j01.ms.22.1.7467