Deboronization Phenomena in Surface Layer of Steel with Carburizing Process

نویسندگان
چکیده

برای دانلود باید عضویت طلایی داشته باشید

برای دانلود متن کامل این مقاله و بیش از 32 میلیون مقاله دیگر ابتدا ثبت نام کنید

اگر عضو سایت هستید لطفا وارد حساب کاربری خود شوید

منابع مشابه

Duplex Surface Treatment of AISI 1045 Steel via Plasma Nitriding of Titanized Layer

In this Study, surface of medium carbon steel (AISI 1045) was modified by titanizing followed by plasma nitriding. Titanizing was performed using pack cementation method, in a pack mixture of ferrotitanium, ammonium chloride and alumina, at 1223 K for 45 and 180 min.  Plasma-nitriding was conducted at two temperatures of 803 and 823 K for 5 h, in a gas mixture of 75%N2+25%H2. The samples were c...

متن کامل

Modeling of acetylene pyrolysis under steel vacuum carburizing conditions in a tubular flow reactor.

In the present work, the pyrolysis of acetylene was studied under steel vacuum carburizing conditions in a tubular flow reactor. The pyrolysis temperature ranged from 650 degrees C to 1050 degrees C. The partial pressure of acetylene in the feed mixture was 10 and 20 mbar, respectively, while the rest of the mixture consisted of nitrogen. The total pressure of the mixture was 1.6 bar. A kinetic...

متن کامل

Modification of EN9 Steel Surface by Salt Bath Nitrocarburizing Process

Nitrocarburizing is a thermochemical treatment which involves the diffusional addition of nitrogen and carbon to the surface of ferrous materials. Usually carried out at temperatures within the ferritic phase field of the Fe-N-C system, i.e. below 593 °C, the treatment improves the resistance to scuffing through the development of a compound layer at the surface consisting predominantly of epsi...

متن کامل

Tribological Characteristics of the Surface Layer of Steel Modified with Boron under Mixed Friction Conditions

The aim of the present work is to determine the influence of technologically produced boron surface layers on the friction parameters in the sliding pairs under mixed friction conditions. The current boronizing processes allow obtaining surface layers of high hardness and high resistance to corrosion and wear, with low brittleness and no tendencies towards cracking However, the operation charac...

متن کامل

ذخیره در منابع من


  با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید

ژورنال

عنوان ژورنال: Tetsu-to-Hagane

سال: 1968

ISSN: 0021-1575,1883-2954

DOI: 10.2355/tetsutohagane1955.54.12_1271