Damping of Low-Frequency Oscillations by Supplementary Control of Power System Stabilizers

Damping of Power System Oscillations Using SSSC - based Supplementary controller

Power-system stability improvement by a static synchronous series compensator (SSSC)-based controller is studied in this paper. Conventionally, the lead-lag structure was used to modulate the injected voltage. But, in this paper, PID controller is also considered. The design problem of the proposed controller is formulated as an optimization problem and Differential Evolution Algorithm is used ...

Design of Wide-area Damping Control Systems for Power System Low-frequency Inter-area Oscillations

Low Frequency Oscillations Suppression via CPSO based Damping Controller

In this paper, the Unified Power Flow Controller (UPFC) is enhanced with a Chaotic Particle Swarm Optimization (CPSO) Damping Controller in order to mitigate the Low Frequency Oscillations (LFO) in a Single Machine Infinite Bus (SMIB) power system. The designed damping controller is an optimized lead-lag controller, which extracts the speed deviation of the generator rotor and generates the out...

A new control strategy for SSSC to improve low-frequency oscillations damping

When power systems are expanded and connected together with weak tie lines, the low-frequency oscillations are increased and the stability margin of the power system decreases. Therefore, when designing the transmission system to be used, it is necessary to maintain the dynamic stability of the power system, and to make sure to have the most possible stability margin. SSSC is a FACTS device con...

Design Supplementary Controller Based on Stabilizing Effect of Delay for Damping Inter Area Oscillations in a Power System

The delay associated with signal transmission through the wide-area measurement system reduces the functionality of the power oscillation damping control system. One of the important issues is the poor operation of the supplementary controller against delay existence, which limits the efficiency of damping of ancillary equipment, such as SVCs in a power system. This paper as a solution proposes...