Damage Behavior of DLC-Si Coating by Vicker's Hardness Test
نویسندگان
چکیده
منابع مشابه
Low-Load Vickers Microindentation Hardness Testing
ADVANCED MATERIALS & PROCESSES • APRIL 2012 I n 1925 in the UK, Smith and Sandland developed an indentation test that used a squarebased pyramidal-shaped indenter made of diamond[1]. The test was developed because the Brinell test (introduced in 1900), which (until recently) used a round hardened steel ball indenter, could not test steels harder than ~450 HB (~48 HRC). They chose this shape wit...
متن کاملReplication performance of Si-N-DLC-coated Si micro-molds
Micro-hot-embossing is an emerging technology with great potential to form microand nano-scale patterns into polymers with high throughput and low cost. Despite its rapid progress, there are still challenges when this technology is employed, as demolding stress is usually very high due to large friction and adhesive forces induced during the process. Surface forces are dominating parameters in ...
متن کاملQualitative Evaluation of Ultra-thin Multi-layer Diamond-Like Carbon Coatings Using Molecular Dynamics Nanoindentation Simulations
Ultra-thin diamond-like carbon (DLC) coatings are used in hard disk drives to protect the intricate magnetic structures from wear and corrosion. The coating on the recording head consists of a hard DLC layer and a silicon (Si) layer that improves adhesion between the DLC layer and the substrate. Damage to this protective coating can expose the magnetic structures to corrosion and compromise the...
متن کاملDLC-Si Protective Coatings for Polycarbonates
In this work, a-C:H:Si (DLC-Si) films were produced onto crystalline silicon and polycarbonate substrates by the rf-PACVD technique from gaseous mixtures of CH 4 + SiH 4 and C 2 H 2 + SiH 4 . The effects of self-bias and gas composition upon mechanical and optical properties of the films were investigated. Micro-hardness, residual stress, surface roughness and refractive index measurements were...
متن کاملVickers Indentation Simulation of Buffer Layer Thickness Effect for DLC Coated Materials
Vickers indentation is used to measure the hardness of materials. In this study, numerical simulation of Vickers indentation experiment was performed for Diamond like Carbon (DLC) coated materials. DLC coatings were deposited on stainless steel 304 substrates with Chromium buffer layer using RF Magnetron and T-shape Filtered Cathodic Vacuum Arc Dual system The objective of this research is to u...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Japan Society for Technology of Plasticity
سال: 2007
ISSN: 0038-1586,1882-0166
DOI: 10.9773/sosei.48.1017