منابع مشابه
Kinematical and Dynamic Aspects of a Cycloidal Planetary Reducer with Modified Structure
The paper deals with some representative geometrical and dynamic aspects of a new cycloidal reducer variant with modified structure, proposed by the authors: geometrical optimization of the cycloidal gear, analysis of the transmission ratio and efficiency, and analysis of the dynamic response in a relevant functioning case.
متن کاملPythagorean-hodograph cycloidal curves
In the paper, Pythagorean-hodograph cycloidal curves as an extension of PH cubics are introduced. Their properties are examined and a constructive geometric characterization is established. Further, PHC curves are applied in the Hermite interpolation, with closed form solutions been determined. The asymptotic approximation order analysis carried out indicates clearly which interpolatory curve s...
متن کاملCycloidal Cyclical Surfaces
The paper presents a family of cycloidal cyclical surfaces, which are created by a movement of a circle alongside the special spatial cycloidal curve, where the circle is located in the curve normal plane and its centre is on this curve. The spatial cycloidal curve can be created by simultaneous revolution of a point about three different axes 3o,2 o and 1o in the space. The form of the cycloid...
متن کاملNew Insight into Cycloidal Areas
1. INTRODUCTION. A cycloid is the path traced by a point on the boundary of a circular disk that rolls without slipping along a straight line. It forms a sequence of arches resting on the line, as shown in Figure 1. It is known that the area of the shaded region below one arch is three times the area of the rolling disk. Our analysis shows that the factor 3 reflects a much deeper property of cy...
متن کاملDevelopment of Canned Cycle for CNC Milling Machine
Despite the tremendous development in CNC programming facilities, linear and circular cuts parallel to the coordinate planes continue to be the standard motions of modern CNC machines. However, the increasing industrial demand for parts with intricate shapes cannot be satisfied with only these standard motions. The proportion of parts which are not covered by the standard CNC motions is certain...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: International Journal for Research in Applied Science and Engineering Technology
سال: 2018
ISSN: 2321-9653
DOI: 10.22214/ijraset.2018.1377