Cyclic testing of a haunched reinforced concrete beam
نویسندگان
چکیده
منابع مشابه
Behaviour of Reinforced Fibrous Concrete Beams under Reversed Cyclic Loading
When earthquakes occur, energy released by the earthquake gets induced into the structure as ground motion and this energy has to be dissipated for safety reasons. To release seismic energy, the structure should damage in such a way that on one hand, collapse of structure should not occur and on the other hand, after the earthquake, damage should be economically feasible to repair. To avoid the...
متن کاملSeismic Behavior of Steel Reinforced Concrete Beam-Columns and Frames
The ability to perform accurate nonlinear simulations is a key component in the assessment of the behavior of seismic force resisting systems. A three-dimensional distributed plasticity formulation for composite beam-columns suitable for nonlinear static and dynamic analyses of composite seismic force resisting systems has been developed. New uniaxial constitutive relations are developed for th...
متن کاملReinforced Concrete Bridge Piers Subjected to Reversed Cyclic Loading
Sixteen large-scale reinforced concrete specimens without web reinforcements were tested to study the behavior of typical bridge piers subjected to deflection reversals that were large enough to cause extensive yielding of the longitudinal reinforcement. The different parameters considered included shear spanto-depth ratio, percentage of longitudinal reinforcement, frequency of the applied load...
متن کاملTapered Polymer Fiber Sensors for Reinforced Concrete Beam Vibration Detection
In this study, tapered polymer fiber sensors (TPFSs) have been employed to detect the vibration of a reinforced concrete beam (RC beam). The sensing principle was based on transmission modes theory. The natural frequency of an RC beam was theoretically analyzed. Experiments were carried out with sensors mounted on the surface or embedded in the RC beam. Vibration detection results agreed well w...
متن کاملExperimental and Analytical Study on Reinforced Concrete Deep Beam
ABSTRACT: Several reinforced concrete deep beams with different L/D ratios (1.5, 1.6, 1.71) were cast and tested in order to investigate the strain distribution pattern at mid-section of the beam. This paper describes analysis of deep beams subjected to two point loading with three different L/D ratios (1.5, 1.6, 1.71) using Non-linear Finite element method (ANSYS 9.0 software). In ANSYS 9.0 so...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Bulletin of the New Zealand Society for Earthquake Engineering
سال: 1979
ISSN: 2324-1543,1174-9857
DOI: 10.5459/bnzsee.12.1.67-71