Cyclic plasticity at pores and inclusions in cast Al–Si alloys

THERMAL FATIGUE RESISTANCES OF 356 AND 413 CAST Al ALLOYS

Abstract: Thermal fatigue is a stochastic process often showing considerable scatter even in controlled environments. Due to complexity of thermal fatigue, there is no a complete analytical solution for predicting the effect of this property on the life of various components, subjected to severe thermal fluctuations. Among these components, one can mention car cylinder, cylinder head and pi...

A Strain Range Dependent Cyclic Plasticity Model

Hysteresis loop curves are highly important for numerical simulations of materials deformation under cyclic loadings. The models mainly take account of only the tensile half of the stabilized cycle in hysteresis loop for identification of the constants which don’t vary with accumulation of plastic strain and strain range of the hysteresis loop. This approach may be quite erroneous particularly ...

Calibration of Hardening Rules for Cyclic Plasticity

In the realm of multi-axial ratcheting, a step by step mathematical approach is developed for the parameter determination of decomposed kinematic hardening rules. For this purpose, key characteristics are mathematically derived for these hardening rules under multi-axial loading. These characteristics are then utilized to develop expressions which relate the loading history to the accumulated p...

Intermetallic Phases Examination in Cast AlSi5Cu1Mg and AlCu4Ni2Mg2 Aluminium Alloys in As-Cast and T6 Condition

Morphological analysis of pores in directionally freeze-cast titanium foams

Synchrotron x-ray tomography was performed on titanium foams with aligned, elongated pores, initially created by sintering directionally freeze-cast preforms using two different powder sizes. Three-dimensional reconstructions of the pore structures were analyzed morphologically using interface shape and interface normal distributions. A smaller powder size leads to more completely sintered tita...