Cyclic plasticity and strain localization in cast γ-TiAl based alloy
نویسندگان
چکیده
منابع مشابه
A Strain Range Dependent Cyclic Plasticity Model
Hysteresis loop curves are highly important for numerical simulations of materials deformation under cyclic loadings. The models mainly take account of only the tensile half of the stabilized cycle in hysteresis loop for identification of the constants which don’t vary with accumulation of plastic strain and strain range of the hysteresis loop. This approach may be quite erroneous particularly ...
متن کاملBoron segregation in a (Fe, V, B) TiAl based alloy
Primary boron containing dispersoids grown from the melt in a Ti-45.5at.%Al-1.6at.%Fel.lat.%V-0.7at.%B alloy, and then annealed at 1473K, have been investigated using optical microscopy, conventional transmission electron microscopy (CTEM) and analytical electron microscopy. The dispersoid morphology is in the form of high aspect ratio plates, hundreds of microns across and cross-sectional widt...
متن کاملStudying the Effect of Productive Factors on Synthesis of Anostructure Tial (Γ) Alloy By Mechanical Alloying
In this research, the Planetary mill was used for mechanical alloying (MA) of Ti and Alpowder mixture with equal at% (Ti50Al50). The effect of various factors, such as process control agent(PCA), speed of rotation of vial and ball-to-powder weight ratio, on process were studied and the bestcondition to synthesis the alloy was determined. Study on X-ray diffraction (XRD) patterns showedthat at p...
متن کاملAtomic Scale Chemistry of α2/γ Interfaces in a Multi-Component TiAl Alloy
We report on the distribution of micro-alloying elements in a multi-component TiAl-based alloy. The specimen contains 3 at.% Nb, 1.5 at.% Cr, 0.5 at.% Mn, 0.6 at.% (W + Hf + Zr), and 0.2 at.% each of B, C, and O. The distributions of all micro-alloying elements with respect to the heterophase interface between α2 and γ lamellae are analyzed with a three-dimensional atom-probe (3DAP) microscope....
متن کاملIsothermal and cyclic oxidation of TiAl composites
Titanium Aluminide and TiAl matrix composites reinforced with alumina fibers (PRD166) were fabricated by powder metallurgy. During isothermal oxidation at 950 and 1070 OC, composites containing PRD166 fibers exhibited larger weight gains than monolithic TiAI; the composites showed evidence of oxidation along the perimeter of the fibers. A fiber reaction, which was observed after oxidation in ai...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Procedia Engineering
سال: 2011
ISSN: 1877-7058
DOI: 10.1016/j.proeng.2011.04.231