CYCLIC DEFORMATION OF 1% Cr-Mo-V STEEL UNDER OUT-OF-PHASE LOADS
نویسندگان
چکیده
منابع مشابه
Mechanism of Bainite Transformation in Fe-Cr-Mo-V-Ti-C Steel
The kinetics and mechanism of bainite transformation have been studied in Fe-Cr-Mo-V-Ti-C steel high speed dilatometry backed by thermodynamic analysis. The complete transformation of austenite, however, has not occurred at any reported temperature. Obtained results confirm the incomplete reaction phenomenon with the cessation of the bainite transformation well before the paraequilibrium is ach...
متن کاملSimulating the Heat Treatment Process of the Shell Liner of Cr-Mo Steel
The aim of the present research is to simulate the heat treatment process of the autogenous grinding (AG) shell liner of Cr-Mo steel in different quenching media (still air, air blowing, oil and water) using ABAQUS software, in order to calculate the cooling curves. In this regard, the microstructure and hardness for each arbitrary point within the mill liner's bulk could be predicted based on ...
متن کاملDynamic Recrystallization under Hot Deformation of a PH Stainless Steel
Dynamic recrystallization, DRX, behaviour of a precipitation hardened, PH, stainless steel was studied in connection with microstructural developments in a compression test. The experimental results showed that the dominant mechanism of softening is DRX, but at high strain rates and low temperatures, ie, high Zener-Holman parameter, Z, work hardening and dynamic recovery, DRV, produced a pancke...
متن کاملDynamic Plastic Deformation of Deepwater Steel Catenary Risers Under Extreme Cyclic Compressive Loading
This paper (SPE 173892) was revised for publication from paper OTC 25335, first presented at the Offshore Technology Conference, Houston, 5–8 May 2014. Original manuscript received for review 20 June 2014. Revised manuscript received for review 27 October 2014. Paper peer approved 4 November 2014. Summary Steel catenary risers (SCRs) on a large-heave-motion vessel are susceptible to compression...
متن کاملStudy of Energy Dissipation in Accordion Thin-Walled Tubes under Axial Cyclic Loads
Energy absorber systems like metallic dampers for controlling the structural vibrations due to earthquake have witnessed considerable development in the past few decades. Also there are some studies on the energy absorption of thin-walled tubes due to impact load. Thin-walled tubes have a large deformation capacity and are suitable energy absorbers in the structure during an earthquake provided...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Fatigue & Fracture of Engineering Materials and Structures
سال: 1979
ISSN: 8756-758X,1460-2695
DOI: 10.1111/j.1460-2695.1979.tb01357.x