CVD Diamond Coating on WC Cutting Tool Using Electrophoresis.
نویسندگان
چکیده
منابع مشابه
CVD diamond coatings on geometrically complex cutting tools
The manufacturing of chemical vapour deposition (CVD) diamond coated shaft type cutting tools is demanding due to the complex design of the cutting edges and the cobalt content of the cemented carbide. The influencing parameters of substrate, pre-treatment and diamond film on the tool cutting performance are discussed. The optimised manufacturing route of CVD diamond coated thread milling drill...
متن کاملOn Stress Analysis of Diamond Coating Cutting Tools
Diamond coatings have been increasingly used in cutting tools applications. Coating delamination is the major tool failure mode and occurs due to deposition-induced residual stresses and thermomechanical loading in machining. This study applies finite element analysis to investigate stress distributions, with the edge radius focused, in diamond coating tools considering depositions and machinin...
متن کاملCutting characteristics of dental diamond burs made with CVD technology.
The aim of this study was to determine the cutting ability of chemical vapor deposition (CVD) diamond burs coupled to an ultrasonic dental unit handpiece for minimally invasive cavity preparation. One standard cavity was prepared on the mesial and distal surfaces of 40 extracted human third molars either with cylindrical or with spherical CVD burs. The cutting ability was compared regarding typ...
متن کاملCharacterizations of nano-crystalline diamond coating cutting tools
Diamond coatings made by processes such as chemical vapor deposition (CVD) have been increasingly explored for cutting tools applications, in particular, for machining lightweight high-strength materials. However, most literature to date reported that the wear resistance of CVD diamond tools is still distant to the polycrystalline diamond (PCD) counterparts. Recently, a microwave plasma-assiste...
متن کاملAnalyzing the performance of diamond-coated micro end mills
A method is presented to improve the tool life and cutting performance of 300mm diameter tungsten carbide (WC) micro end mills by applying thin (o300nm) fine-grained diamond (FGD) and nanocrystalline diamond (NCD) coatings using the hot-filament chemical vapor deposition (HF-CVD) process. The performance of the diamond-coated tools has been evaluated by comparing their performance in dry slot m...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Journal of the Ceramic Society of Japan
سال: 2001
ISSN: 0914-5400,1882-1022
DOI: 10.2109/jcersj.109.1273_782