Cutting Temperatures in End Milling of Compacted Graphite Irons
نویسندگان
چکیده
منابع مشابه
Cutting Force Prediction in End Milling Process of AISI 304 Steel Using Solid Carbide Tools
In the present study, an attempt has been made to experimentally investigate the effects of cutting parameters on cutting force in end milling of AISI 304 steel with solid carbide tools. Experiments were conducted based on four factors and five level central composite rotatable design. Mathematical model has been developed to predict the cutting forces in terms of cutting parameters such as he...
متن کاملAnalytical Modelling of Surface Roughness during Compacted Graphite Iron Milling Using Ceramic Inserts
This study investigates the effects of the lead angle and chip thickness variation on surface roughness during the machining of compacted graphite iron using ceramic cutting tools under dry cutting conditions. Analytical models were developed for predicting the surface roughness values of the specimens after the face milling process. Experimental data was collected and imported to the artificia...
متن کاملModeling of three-dimensional cutting forces in micro-end-milling
A new nominal uncut chip thickness algorithm for micro-scale end-milling is proposed by considering the combination of an exact trochoidal trajectory of the tool tip and tool run-out, and then the actual uncut chip thickness may be obtained from a comparison between the current accumulative uncut chip thickness and the minimum chip thickness. Due to the intermittency of the chip formation, the ...
متن کاملIntelligent Adaptive Cutting Force Control in End-milling
In this article, an adaptive neural controller for the ball end-milling process is described. Architecture with two different kinds of neural networks is proposed, and is used for the on-line optimal control of the milling process. A BP neural network is used to identify the milling state and to determine the optimal cutting inputs. The feedrate is selected as the optimised variable, and the mi...
متن کاملGraphite Phase Formation in Al Alloyed Ductile Irons
The influence of aluminum, within the range of 0.08 - 6.16 wt.%, on the microstructure and hardness of as-cast ductile cast iron has been studied. A number of irons of different composition have been made by green sand casting and gravity die casting of appropriate design to provide the experimental materials. It has been found that Al addition and higher cooling rates in permanent mould castin...
متن کاملذخیره در منابع من
با ذخیره ی این منبع در منابع من، دسترسی به آن را برای استفاده های بعدی آسان تر کنید
ژورنال
عنوان ژورنال: Procedia Manufacturing
سال: 2018
ISSN: 2351-9789
DOI: 10.1016/j.promfg.2018.07.056