Cutting Process Simulation of Titanium TC4 Based on DEFORM-3D

Optimization of Cutting Insert Geometry Using Deform-3d: Numerical Simulation and Experimental Validation

In this research work an attempt has been made to minimize flank wear of uncoated carbide inserts while machining AISI 1045 steel by finite element analysis. Tool wear is the predominant factor that causes poor surface finish and is responsible for the dimensional accuracy of the machined surface. The quality of component produced decides the effectiveness and competitiveness of any manufacturi...

Finite Element Simulation of a Friction Drilling process using Deform-3D

Friction drilling Process is a rotating conical tool to penetrate the work piece and create a bushing in a single step without generating chips. This work investigates the finite element modeling (FEM) of large plastic strain and high-temperature work-material deformation in friction drilling. The workmaterial deformation is very large, and both the tool and work piece temperatures are high in ...

Numerical Research on Dynamical Behaviour of Alloy Titanium Tc4

3D-Planning of construction site equipment based on process simulation

Current approaches in planning building site equipment evaluate static periods, e.g. construction phases. As a consequence these states provide a rudimentary optimized layout plan, however without considering the material flow and corresponding interactions in a precise form. Due to dynamic processes, which could obstruct the material flow, an adaption of the equipment layout during individual ...

Simulation of Cutting Process in Turning

This paper presents simulation of cutting process by turning of polyamide PA 66, the simulation based on approach Arbitrary Lagrangian Eulerian, ALE. Was taken into account a tool knife CNMA from Coromant. The flow stress of the workpiece is modeled as function of strain, strain rate and temperature, so as to reflect its dynamic changes in physical properties. In this way, the influences of dep...